Chrysler Pacifica Recirculation Door Actuator Replacement, Part 2

Рет қаралды 1,270

Isaac Repairs Everything

4 ай бұрын

Chrysler Pacifica Recirculation Door Actuator Replacement, Part 2
HVAC recirc door

Пікірлер: 8

@micahtawney1 3 ай бұрын

Thank you for this guide, you were extremely helpful. It's incredibly frustrating and it helps to have a pair of small hands nearby for turning the blade to fit the new actuator in. I did lose a 5.5mm socket and a small extension into the abyss so hopefully those won't rattle

@isaacrepairseverything 3 ай бұрын

Glad it helped!

@elbeefolargo 3 ай бұрын

So you had to move the flap to get the new blend door actuator on? Having a hard time getting the new one to slot in. EDIT: So I got it in. Ended up starting both screws and then wiggling the flap to get it seated correctly. Laying on your back looking up from under the dash was much easier than going in from the side.

@jawne7305 Ай бұрын

A lot of videos on the passenger side actuator. But there is also a second actuator on the driver's side that can go bad. Wondering where there are videos on how to replace the driver's side actuator is.

@isaacrepairseverything Ай бұрын

This isn't the passenger or driver blend air door actuator. The passenger one is on the left side of the passenger footwell area and I assume the driver one is opposite. This is the recirculation door actuator, which happens to be on the passenger side. If you need to change the passenger blend air door actuator, it is a different part number and it has a finger that rides a slot on an arm attached to the actuator. The process is the same except you need to make sure you align the slot and the finger. I haven't looked for videos on that though. I assume the driver side is the same.

@jawne7305 25 күн бұрын

@@isaacrepairseverything The driver's side is not the same unfortunately. I tried to remove it but there are like two levers being held together by the actuator. The actuator looks the same but if you try to pull it out, you have to also pull these levers that are being held down by it and I wasn't about to go down that rabbit hole from them possibly falling out and I not know how to put them by in. The one on the passenger side seems simple as it is not holding down other pieces that may fall out.

@isaacrepairseverything 25 күн бұрын

@@jawne7305 Ah, I haven't had to work through that yet so I can't advise at this time.

@charleshom3133 5 күн бұрын

@@jawne7305 Were you able to resolve it or did you end up taking it in? I believe I have the same issue. I wasn't able to locate the driver side.