😂 that’s the point! I want anyone to be able to do this stuff. I’m glad you appreciated it!

Thank you!! This is why I do it! 🤘

Get it all back together just to watch gas pour out of it and do it again 😂

I take a Q-tip, cut it in two and stick the shaft in a drill. Dip it in Brasso and use that to polish the inside of the seat. Rinse with carb cleaner.

😂😂 that’ll cause an issue

I’ve got one but only use it on carbs that bust my berries 😂 98% of the time carb cleaner and compressed air have worked for me. I’m glad it helped!

Nice!

This forum has some good info! Looks like it works hand in hand with the thumb throttle switch so make sure your slide isn’t stuck open www.snowmobileforum.com/threads/magnetic-carb-switches.3542/

Thank you! I don’t right now. I just make videos on stuff I’m doing to fix other peoples stuff and that hasn’t needed done yet. I’m sorry. I appreciate that tho!

Nope!

I did so you have more room to work on it!

Some sleds from the factory have each carb jetted differently on purpose due to heat difference on each side. If they’re jetted the same and the bodies are identical I wouldn’t think it would matter!

I searched the sled and found a website that listed oem part numbers then put that part number into Amazon. I haven’t tried this part but for $10 I’d try it amzn.to/3VK6RhX

I just bought new ones of the Arctic cat dealer with the clips !

I’d say that’s definitely not normal 🤔 it’s possible the needle and seats aren’t seating but the way the vent lines are routed it would fill the motor I think before it came out of the vent line.

@@ToyShopRestorations any suggestions where I should look, or what I can do?

@@ToyShopRestorations I watched your video again and think maybe I put the float fingers on upside down, does that sound like it could be the cause?

And I have the exact same on mine I have a 1996 puma 340 I almost got it going, but I just need to figure out some carb issues and I never did clean out my needle seat. I probably should do that. And I think I need to get a hose like that for mine because it's just open it it's drips fuel out.

If you have any other tips, let me know. Thank you.

www.ebay.com/itm/124317578599?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=5psyAZEHS_y&sssrc=2349624&ssuid=39xyh32ctx6&var=&widget_ver=artemis&media=COPY Your needle doesn’t have the clip. Most needles do have the clip but it’s not a big deal because yours was designed to work without it. It also looks like your needle doesn’t have a rubber tip it’s all metal. So I would make sure the seat is really clean. If there’s and crap in there where it seats it won’t be able to seal off the flow of fuel. The rubber ones seem to be a little more forgiving lol Not sure what hose you’re talking about? 🤔 the overflow fuel lines?

I don’t see why not 🤷🏻‍♂️ I feel like carb cleaner is cheaper than brake cleaner so I always use that. But if that’s all you have laying around sure!

Ya not all of them are this easy lol I've had some doozeys