this is how I clean the boomlines and hopper of my concrete pump
Пікірлер: 73
@mergaz139 жыл бұрын
for some reason this video gave me great satisfaction
@That_one-guy1927 жыл бұрын
I guess we must just be really lucky. Every job we pour residential or commercial has a washout pit for us on site. The only time we'll drive back with concrete in the truck is if we're about to have a boom party.
@joelopez7925 жыл бұрын
Harland Gambill hahaha yuup same here
@Canibal_Animal11 жыл бұрын
I just make sure there isn't any water on top of teh concrete in the hopper, and pump wide open either on the ground or back in the mixer till nothing comes out of the hose. Then, I put some water in the hopper and suck my ball back. You never want to leave a schwing stroking while washing out, it will wear out the kidney seal with no concrete in it. You really only have to stroke a schwing one time to wash it out anyway
@user-kp7pk2dk8f11 ай бұрын
BRAVO 👍
@xavichaves65503 жыл бұрын
El problema es que cuando te marca tapón lo primero que se daña es el enpaque de codo de arranque es solo mi opinión compita 🇲🇽👍🌑🇲🇽
@theflyguy66611 жыл бұрын
New operator can't wait to get started
@yz125ryder5 жыл бұрын
you still an operator?
@EliRivera-do5nc Жыл бұрын
@@yz125ryder lol
@devilish344 жыл бұрын
that not enough water to do anything but waste time and make a mess
@Kyleandkristin11 жыл бұрын
what water nozel set up are you using, that's what I need!
@pacificdynamicbuilders43807 жыл бұрын
I don't have boom pump but i pump a lot of concrete. My question is why not just shove the ball in the hopper, fill it with water and pump it out? i don't understand the reverse part? thanks
@ludodens7 жыл бұрын
hi 20 years ago we did it like you said. clean the hopper.... than fill it up with water and pump it trough. than we had a job in berlin were we did not leave the site with the pump. we had to change something to rince out the lines. so we tried it this way. the conclusion was that the inside of the conretelines was cleaner this way. because when you drive to the plant, the grout slips to the downside of the lines and gets stuck there.
@ionutgrozav72643 жыл бұрын
Hello! I recently buyed a concrete pump and I am afraid to suck the sponge because I have no bolt to block the sponge not to get destroyed. Can I cause any damage doing it?
@calvinbell31263 жыл бұрын
No damage would be done to the pump but you'll cut the sponge in half if you suck it in too far
@ludodens52783 жыл бұрын
once the sponge ball comes into the wider part of the lines it will stop. use the right size of ball.
@billm61718 жыл бұрын
a good video, very informative. you sir seem very thurogh and neat i like that.
@theeverydayconservativelos2177 жыл бұрын
Yes, that an "old school" water wash. We were taught to do it this was when we were running Thompsen 875's and 2001's. Those hoppers were too big to fill, so we sucked buckets back.
@yunierperezsoto49056 жыл бұрын
que lindo es operar ese equipo
@tereaguilar98329 жыл бұрын
How much do one of these bad boys Cost to own a used one ? Thanks
@handlebullshit8 жыл бұрын
That's what she said. 1:49
@LM.P6 жыл бұрын
Slim Pickings ha
@k4bloggs12 жыл бұрын
i dont waste any of it and only fill the hopper to how much the customer needs.i dont make any mess also
@rizwansheikh27497 жыл бұрын
great job. and what is this orange colour on the boket
@ludodens7 жыл бұрын
Raza Shaikh you mean on the hopper? it is a vibrator when you have to pump dry grout (slump 2)
@rizwansheikh27497 жыл бұрын
Ys ys
@rizwansheikh27497 жыл бұрын
Thanks i want learning pump
@hadejproc79716 жыл бұрын
What type of pump is it? 6x4 ? Putzmeister???
@ludodens6 жыл бұрын
34m schwing 2006 model
@criminallyinsane0010 жыл бұрын
Dan kende de marc D.W. mss ook die rijd nu voor holcim in herentals?
@ludodens10 жыл бұрын
ja die ken ik doe hem de groeten
@criminallyinsane0010 жыл бұрын
Zal ik zeker doen na het verlof;^)
@ludodens10 жыл бұрын
moet ik nog wa filmkes op facebook zetten?
@criminallyinsane0010 жыл бұрын
Das altijd interesant e
@frankstephen80876 жыл бұрын
I think the 45 mint drive is much because that water is not enough for cleaning
@2011gmh11 жыл бұрын
Where I am from we let the pump guys wash out in the concrete trucks as a duty and courteousy . By the way I was a concrete truck driver for over 20 yrs. Sorry you dont get the same:)
@theeverydayconservativelos2177 жыл бұрын
that is the cleanest and fastest way for everybody to get done and on to the next job, safely ! Water washing is 100% proper technique and if done properly you can put ALL the mess back in the truck to be hauled away. Customers LOVE that and so do the op's. Simple. The op MUST know a few things....how many strokes it takes to get to the end of the boom, or the high pt then free fall (gravity assist) what speed to Water Wash, low rpm mid vol, and what shape the mud in the boom is in. If its too tight, simply recirculate to loosen it a bit. NOT too loose, remember water and concrete cause separation, so use good judgement there. IN 40 yrs W water washing everything from thompson 2001's , Elba Sheele's and other 'forgotten' models, all the way up to 63m long booms, I NEVER had a tip hose blow out of a truck drum or have a problem. Drop the tip hose in just enough to lay down in/on the charging chute so its aimed into the drum, and pay attention when the flow starts as it MAY try to climb up slightly...from the tremendous thrust exiting the hose...just lower it a bit. 3 seconds later you're done....Lift out, avoid dripping grey water on your best friends drum and fold up and GO !
@timwalcott31694 жыл бұрын
Evidently you guys don’t know how to properly water wash a boom back into the mixer. You save the huge mess in the road and your clean up time is reduced as well? Wow????
@sanjaypawar390411 жыл бұрын
verygood
@techniconconstructio9 жыл бұрын
Great video. Can you send me the pictures and video ?
@aryabimatimur292611 жыл бұрын
good
@brournemouth8 жыл бұрын
A lot more work and attention that I'd imagined, never having done this task. I can see how a lazy operator could do a half-assed job and leave a hell of a mess.
@TrekCompsport9 жыл бұрын
what would happen if i tossed a wrench into the hopper,theirs this one pump operator that i can't stand
@ChuckJolley8 жыл бұрын
+Trek Compsport I've pumped a framing hammer through a 32m Putzmeister. It never missed a beat.
@TrekCompsport8 жыл бұрын
+Chuck Jolley. :(
@ChuckJolley8 жыл бұрын
+Trek Compsport Well, not on purpose of course. I assume it came in on the mixer truck.
@dubnine4278 жыл бұрын
+Chuck Jolley how didn't that plug the lines? What were u using 5inch line??
@ChuckJolley8 жыл бұрын
+Dub Nine Yes, boom pumps are piped with 5" line.
@aryabimatimur292611 жыл бұрын
yes
@zabeehullah3587 жыл бұрын
zabeeh Ullah
@stojko07611 жыл бұрын
34 best
@ludodens11 жыл бұрын
the water-setup in this video is the original setup from schwing. if you send me your e-mail adres i will send you detailed pics, goodnight.
@alexanderrojas92106 жыл бұрын
ludo dens you must go thru kidney seals like crazy leaving your pump stroking in reverse. Like a rookie schwing don’t need to be stroking to wash out. Putz you do, schwing you clean one cylinder at the time or you wear your kidney seal.... #FuckYousSchwing 🖕🏻😂
@user-ob7jb9ug9l6 жыл бұрын
Alexander Molina 0
@ahmedbenguermoud54442 жыл бұрын
chikh
@user-yq4we2mx5q6 жыл бұрын
Shwing Shteter
@chrisserpas629810 жыл бұрын
sorry but i see no point in the water before the ball pointless i can clean out my 32 in less then 10 mins from popping the swing 90 u spent extra what 8 are 9 mins getting buckets filling with water then after u make a huge mess and u loose 40 gallons of your 100 are more in sucking the ball back
@ludodens10 жыл бұрын
dear Chris first i want to say to you to read my comment on my video "this the way I do it" I never said it is the right way or everyone should do it like that. secondly I don't waiste time to fill up the buckets because the mixer drivers do it for me while they are mixing or filling the hopper. the water I use is never my water from the pump. the point of the water sucking back is to clean the insides of the boomlines at first, and second to be able to drive to a faraway concrete plant to washout the hopper if on the working site is no place to washout. thing is just to avoid a mess on the construction site. most contractors don't appreciate when you clean out the hopper on their site, because afterwoods they have to clean the site for their customers.
@loughwell5 жыл бұрын
For fucks sake!!!
@aryabimatimur292611 жыл бұрын
yes yes yes
@hyunjinlee98219 жыл бұрын
한국 korea 에서는 이렇케 힘들게 안함 자동으로 청소함 공필요없음 레미콘 물 차 오던지 펌프카 물로 다쏴버림 청소 하는대 1분도 안걸림
@juliusceasardeleon44109 жыл бұрын
too much time
@nowinthailand59474 жыл бұрын
Cowboy ...
@kim_sung_kyu306 жыл бұрын
for Moronrtgawe
@ekramulislam99883 жыл бұрын
Iekdamul
@ekramulislam99883 жыл бұрын
9101652684
@ekramulislam99883 жыл бұрын
HS Ka Aata Hai humko phone number
@ekramulislam99883 жыл бұрын
Yah machine ka contract chahie ham kahan se khol sakta