Hey everyone! This is a video about my cnc dovetail process. Comment on the video if you want me to post my Mozaik parameters. Thanks for watching!
Пікірлер: 16
@JorgeCruz-us3ep4 ай бұрын
They look sharp! interested for sure!
@jefffenske8982 ай бұрын
looks great, could you share your mozaik parameters?
@bumrush77212 ай бұрын
That looks great Id like to try this out in Moz too. Id appreciate the settings info. Thanks!!
@Microjig14 күн бұрын
This is awesome! I have not had the chance to try dovetails with our bit on my CNC. The other difference between our bit anf the Vortex is that the radius at the top on ours does NOT end with a horizontal cutting edge, but flairs up and out so even if the depth is a bit off, no lines will be left behind.
@jeremiahnielson14 күн бұрын
100%! It’s like the bit was meant for this operation. Absolutely perfect. To be honest, I haven’t even used it for the intended purpose. Only for building dovetail drawers on the CNC.😬. Haha! It’s a very high-quality bit too! I’ve cut miles of dovetails with it and haven’t replaced it yet. Great job guys!
@Microjig14 күн бұрын
The roundover at the top is 1/16", at the bottom tips it is 1/32"
@ottootto41035 ай бұрын
Awesome, may I see the settings or if you have a video?
@jeffthibeault79574 ай бұрын
I use Mozaik and would like to get more information, thanks.
@CisnerosShop4 ай бұрын
I’d like to see the parameters for this tooling
@wilsonmatos6734Ай бұрын
Thank you for saving me $675
@josholtrogge18166 ай бұрын
Hi, I'd love to see how you did this with the microjig dovetail bit. I just bought the vortex set but haven't used it yet. I'll definitely send it back if I can figure out your method. Thanks!
@jeremiahnielson6 ай бұрын
Hey sorry I didn’t respond earlier. I’m going to make a video on the settings soon but until then I’ll send you a screenshot. But there’s a little bit more involved than just the settings. I changed the diameter of the bit so it would travel a little further.
@josholtrogge18166 ай бұрын
Thanks!
@Frozen0343 ай бұрын
The router bit from microjig, doesnt the rounding go upwards, insted of out to the side, isn’t that a problem? how did you get the rounding perfect? 😮 😀😀 i would love to make this on my new and first CNC 🤩👍👍
@Microjig14 күн бұрын
Our bit does "flair" at the top. We have a patent on that feature. But if your set up is right, the horizontal cutting edge on the Vortex Bit should not be touching the stock either. With our desing, if the stock runs a bit thick, the cutter will not leave a telltale line along the edges of the joint.
@jeremiahnielson14 күн бұрын
There’s a little trial and error during set up but it’s just like setting up a dovetail jig. If you dive into deep, the it will be too loose and if you cut the pocket to shallow you’ll have a gap. I’ve been too busy to make a follow up video explaining the process but I will soon.