Co2 Vs Diode Laser Cutting and Engraving: BEFORE YOU BUY! 2024

Рет қаралды 1,324

Ай бұрын

Watch this video before you buy a laser cutter or engraver. I go over the many differences between the two, and I may save you some money.
My best selling Lightburn files on ETSY: www.etsy.com/listing/16844011...
Longer Ray5 5-10w Laser: shrsl.com/4jr45
Atomstack Ace Pro v2 20w: shrsl.com/4gfvk
Valley10 - Ace Pro V2 10% off
Roly LaserMATIC Mk2 30/10: rolyautomation.com/XCUDsk
xTool S1 20/40w: bit.ly/3U5c9Vz
Atomstack A70 Pro: shrsl.com/4g1u6
affa70pro - A70 Pro 100$ off
Monport Onyx 55w Co2 Desktop: bit.ly/4bwX2eN
OMTech Pro 150w Co2: omtechlaser.com
Aeon Laser: aeonlaser.us/redline
Thunder Laser: www.thunderlaserusa.com/machi...
Craft Closet 10% off (wood and acrylic): craftcloset.com/discount/VALL...
Recommended Review Channels:
Clack Shack: / @theclackshack
Ventauri: / @vintauri
Louisiana Hobby Guy: / @thelouisianahobbyguy
Light Source Engraving: / @lsengraving
Valley Forged:
Etsy: valleyforgedshop.etsy.com
Facebook: / valleyforgedgoods
Instagram: / valleyforgedgoods
All opinions are my own. Leave yours below

Пікірлер: 5

@FredSchmitthammer Ай бұрын

I was surprised that the XTool P2 was not on this list. I really enjoy your channel and your Etsy shop. Because of you, I have started learning about leather projects with the laser. My WeCreat Vision is getting a workout. Hopefully a business will come next year. Thanks again!

@ValleyForged Ай бұрын

It was already so long, I can't cover it all. BUT, I would say the P2 is good, but perhaps too expensive compared to the Polar, or ONYX. It also works best in XCS, which is not bad, but when you want to upgrade you will likely want Lightburn.

@2008albaladejo Ай бұрын

great video very informative

@numara585 Ай бұрын

Thanks for the valuable information, I’d like to start a small business using one of these laser engravers but still hesitant if it’s profitable as my main source of income, can you share us your thoughts.

@ValleyForged Ай бұрын

It is a 'get rich slow' business. I would start part time with the 20w or the Roly 30/10, and spend a year learning and getting your 'niche'. I have many videos on this subject. Perhaps check out the 10 ways to make money first. :)