Only some RS3 models have it, not all. I do not think any standard 8Y models have it. You can get it retrofitted however from third parties.

Any questions let me know!

It works fine as you can see, no reason why the US car would not work.

From when I looked through it seemed like everything was enabled however that was a Launch Edition RS3. I don't know on a base car or Vorsprung.

The only reason I got it was to turn the fake pumped in noise off

There is quite a debate about Lane Assist - it is a safety feature. If you set it to “early” it will keep you in your lane and auto-steer for you. Of course you need to be ready to take over any time and it doesn’t work on every road and it is time limited but I’ve never had an issue driving the car like this. However, in answer to the question - you can turn it off in the settings and you do actively have to select it for it to come on by using the stalk by the wheel.

Had a look all over the settings to turn it off, and no where could i see in the settings can it be done. It's always on and you can only turn it off with the indicator stalk holding the end button.

Yes, you can use it for that but they look better on.

You can reverse any changes you make using the backup function but I’m not sure any dealer checks are going to look at if you changed the DRL duration or turned it off.

No it wont interfere with your warranty

I'm pretty sure the worst case scenario the dealer does a deep scan , any modules that you have coded would just get flashed back to stock form

Yes, you can but I honestly think that you shouldn’t. It isn’t going to mess with your driving as long as your not swerving across lane and it is a safety feature.

@@TechInTheCar It would be nice if it remembered my last setting. All our work response cars have it disabled along with autonomous braking for safety reasons.

OBDeleven should not void your warranty as it’s not an engine map that will show on scanning at the dealer and it is fully reversible.

@@TechInTheCar ok thanks What kind of improvement can you see from this in terms of bhp

@@edoz3279 zero ? this device is not for tuning. Mainly used as a code reader/clearer and long coding for adaptations.

Yes, those functions will be able to be activated if the hardware is there and it will work on every Audi including the standard 8Y A3.

Yes, it will work the same. You may have different one-click app options but it works the same way.

You need the brand new OBD eleven to do it.

@@TechInTheCar come si fa?

@@TechInTheCar do you have a link to the newest one with SFD?