Common way mower shops and dealerships rip you off! Plus how to save $$$ buying a PTO clutch.

No video

Common way mower shops and dealerships rip you off! Plus how to save $$$ buying a PTO clutch.

Рет қаралды 2,239

Mechanical Mind

Күн бұрын

Пікірлер: 14

@Mechanical_Mind 4 ай бұрын

To be able to remove tough bolts and nuts with ease take a look at these DeWalt impacts I use amzn.to/49NwEfk

@jayjudd6518 4 ай бұрын

This guy is a genius, just watch and learn. 😊

@stevecrossland3681 4 ай бұрын

Another great video thanks for the tips. Say, do you know of a place where you can get zero-turn dampers? I have a 2017 Toro TimeCutter HD with MyRide 54". Toro in Canada wants over $200 for them.

@Mechanical_Mind 4 ай бұрын

Thanks Steve, no I don't have any recommendations on dampers. Now that I'm working fully for myself I don't have a parts department to find stuff for me. I'd just try to look up what name and part is on the current ones you have.

@stevecrossland3681 4 ай бұрын

@@Mechanical_Mind Yup, I did that and emailed them, but no reply. Thanks anyway.

@darwindropmazda 4 ай бұрын

Really good video!

@user-pc2wo9vm2k 4 ай бұрын

Grease the bearing

@sherrischneider2794 2 ай бұрын

Do not loctite that clutch bolt. Instructions say not to do it. Just use torque wrench only.

@Mechanical_Mind 2 ай бұрын

Many new clutch bolts come with red loctite already on the bolt.... I never use red loctite on them. Most of the time I use anti seize on the clutch bolt on models I've know have issues with the bolts backing out or weak lock washers from the factory. Instructions will vary depending on the manufacturer. They are humans too and believe me they make mistakes. Instructions will come out the next year saying to correct mistakes caused from previous instructions 🤣

@LNRRidez 4 ай бұрын

I've got an issue with my Husqvarna YTH24K54 riding mower. It keeps kicking the belt on me. I've replaced all the spindles, pullies, blades and hardware on the deck along with the pto clutch. It's still kicking it off. Any suggestions?

@thomasalbert6202 26 күн бұрын

Did you replace the belt?

@jstpsgthru 4 ай бұрын

Thanks for another great video. I would appreciate it if you could help me, again. My mower is a 17 yr old/450 hr Cub Cadet i1046. It runs good except for the problem I'm hearing. When I engage the PTO, there is a hesitation then it engages but sounds weak, like it slips a little bit. The "lower" DRIVE belt was replaced about 7 hrs ago. Is it your opinion that it is likely the PTO? And, may I lay this mower on the side or flip it vertical to replace the PTO, without oil spilling everywhere or experiencing some other problem? Thanks, very much, for your kind assistance.

@Mechanical_Mind 4 ай бұрын

You might have an oil leak that is letting oil get into the clutch. OR it's just worn out. I'd check to make sure all the spindles and pulleys on the deck are spinning easy and not in a bind. I wouldn't lay it on the side. I normally just jack the front up and use jack stands to hold it up.

@jstpsgthru 4 ай бұрын

@@Mechanical_Mind Thank you, sir! Will do.