What's the difference between a standard set of rockers for the A-Series engine and a set of MED roller-tip rockers?
Пікірлер: 15
@duffield55aj4 жыл бұрын
Again nice engineering, material and heat treatment of the roller and pin is very important. Nice job, will have to visit your works and have a look at your products for my next project.
@alfiemiller38563 жыл бұрын
What set up would you recommend for Road use when running a 266 kent cam, twim hs4 and stage 3 head on a 1380cc. 1.3:1 or 1.5:1? Thanks!
@shriramvenu5 жыл бұрын
how do the basic red roller rockers compare to the cooper s2 rockers?
@MEDEngineeringTechVideos5 жыл бұрын
They give marginally more lift at 1.3:1
@thebibidu Жыл бұрын
What should I use on a 12G295 ? Thanks
@miniukpro204 жыл бұрын
Will the 1.3 red rockers fit ok on the 12g295 head ?
@MEDEngineeringTechVideos4 жыл бұрын
No, these will only suit the 1275 cylinder head valve spacing.
@miniukpro204 жыл бұрын
@@MEDEngineeringTechVideos thanks for the fast reply
@franktaylor76172 жыл бұрын
😎👍
@tommywatterson5276 Жыл бұрын
Roller top rocker arms would be an unnecessary pain over standard rocker arms. You have to do push rod measurements, watch the roller space covered on top of valve stem.
@Gregory_P.4 жыл бұрын
Which one set works best in a stock mpi engine?it has only full exhaust and air filter.
@MEDEngineeringTechVideos4 жыл бұрын
If you're looking for a little more performance, the 1.5s.
@Gregory_P.4 жыл бұрын
@@MEDEngineeringTechVideos The stock units are 1.3?
@MEDEngineeringTechVideos4 жыл бұрын
Usually around 1.28 but they can vary massively
@walterramirez81343 жыл бұрын
1.5 work exelent in mpi. Valves GAP (clearens) is diferent.check for properly adjustment