Concrete Spread Footing Design (ACI 318-19)

Рет қаралды 4,066

Күн бұрын

Follow along for a quick video about designing a concrete spread footing in accordance with ACI 318-19
CalcBook empowers structural engineers to produce deliverable quality design calculations within minutes. Beam loading is a recently added design tool added to CalcBook that helps users design steel and concrete beams.
www.calcbook.com/
0:00 Introduction
0:42 Problem Statement
2:03 CalcBook
7:05 Bearing Pressure
9:43 Flexure Demand
10:58 One-Way Shear Demand
11:40 Two-Way Shear Demand
12:18 Sliding
13:48 Overturning
14:13 Flexure Capacity
14:50 One-Way Shear Capacity
15:14 Two-Way Shear Capacity
More CalcBook Videos:
Lateral-Torsional Buckling: • Lateral-Torsional Buck...
Shear Wall: • Concrete Shear Wall De...
Concrete Beam: • Beam Deflection
T-Shape Bending: • CalcBook Custom T Shap...
Bolted Connection: • CalcBook Simple Bolted...
Single Angle Flexure: • Single Angle (L-Profil...
Circular Weld: • Video
Composite Member: • Composite Beam Flexura...

Пікірлер: 12

@Fratasims1 4 ай бұрын

Excellent Presentation and Graphics! Do keep up same and continue the Sharing!

@calcbook 2 ай бұрын

Thanks! Any videos or design modules you'd like to see?

@gnidnoeled786 2 ай бұрын

For sliding capacity : Why 1 foot is excluded to get the triangular pressure acting on the pedestal and footing? Is it per the code? What about the P to use? Is it P = axial load of the column + column self weight only? Thanks in advance for the reply.

@calcbook 2 ай бұрын

Hello, and thank you for your great question! In some geotechnical reports, engineers may recommend excluding the top 1 foot of soil when calculating passive pressure for sliding resistance, unless it's covered by concrete or asphalt. CalcBook provides designers with the flexibility to choose whether to include or exclude this top 1 foot based on the geotechnical recommendations. For specific guidance tailored to your project, please consult your project's geotechnical engineer. The 'P' used for frictional resistance consists of the applied load (user-entered), footing weight, pedestal weight, and the soil weight above the footing. Note that CalcBook allows designers to select whether to include the footing weight, pedestal weight, and soil weight in the left input pane. This selection applies across all capacity calculations. Thanks again for your excellent question!

@wesleybrewer3002 Ай бұрын

When you are looking through the calculations in the software, does it have ACI code refences you can view?

@calcbook Ай бұрын

Hi @wesleybrewer3002 In the calculations, there is a reference pane along the right hand side of the calculation that refer to the section of ACI 318 where the equations or factors are taken from in the code. An example of this can be seen in the video around 14m20s mark in the “flexural capacity” section of the calculation (references are provided for beta, compressive strain, tensile strain, and phi, for example) Due to copyright, we cannot include explicit snips from the code itself, as only ACI has the rights to sell and distribute their codes. Hope this helps! If anything else, please ask.