One I built hundreds of these engines, and always put the journal at the bottom of stroke so to not fight the counterweights and can easily put on the caps! Two does not show pressing in the liner to seat it, want to make sure that filler band is all the way in! Also made two long puller bolts warped in shrink wrap to protect journal as I pulled down the piston group! Worked really well!

Love the way he uses a blade to get the easily damaged bearings out of their plastic wrappings.

No the bearing Tang/fang is for bearing centralization in the connecting rod not to prevent bearing from rotating

How about liner protrusion..that one must check before putting the line with the seals?

The tangs are only for bearing positioning, bearing crush are responsible for bearings not to spin

Я ВАШИХ ФАНАТЫ ВЫ ЛУЧШИХ БЛОГИР Я ДВОРНИК МОСКВЕ BRABUS MANSORY

I like the way He Works Nice and Slow the way it should be

Using Torque wrench as a breaker bar for the 60 degrees?

The best channel ! Bravo colleges...

Nice video boss

So they do everything right and professional but do degrees with torque wrench and give it about 60°

Amigos ,mi motor 3306 de inyección directa avienta mucho humo, moja las válvulas de escape, pero está anillado

The alignment dowel pins on the connecting rods aim upward towards the front of the engine, as they should. At 3:14 however, when the technician shows the cap, he is installing the cap with the dowel pin holes aiming downward toward the rear of the engine. They won't line up with each other.

Le travaill natirelle j'aime trop ça

Very good 👍

It’s suppose to be 90 degrees there was a typo in he’s script or they are different cus oem cat requires 90 degrees

🤤I love new engine parts.

Sir i suscribed your video and like it but nobody reply me i want gep 65 _3 perkins olupiyan 60 kva generator it is 4 cylinder plz make video on valve adjustment tappet and its firng order plz sir

What is the position of piston?

I'm enjoying this

You in Europe succeed at Repair of the machine

Final Torque applying method is wrong....

¿ NO ES POSIBLE TRANSMITIR EN ESPAÑOL?

Please engine crankshaft and camshaft and pump full timing mark sent thank you Sir

Je suis à la recherche d'un emploi et j'ai de l'expérience dans le domaine, si possible, j'attends votre réponse.

How can I contact I need CTP parts for 3406 engine ?

Beautiful

MTZ 1221 set to order??

❤

Asia qe lado apuntan las gias dela biela de un 3406 mecanico

ok vre good

👏🏻👏🏻👏🏻

Cat c15

bom noite. Jean Jacques. mecani completo

خوش كتر

almando caterpillar 3512

Ok

need employ?

Need employees ?

piezas alternativas para un motor CATERPILLAR?....JKAJKAJAJKA

P

Volvo

These guys sucks. I’m way better at installing con rods

It’s suppose to be 90 degrees there was a typo in he’s script or they are different cus oem cat requires 90 degrees

❤