Quick tip… before you go to change the oil let the mower run about 5 to 10 minutes to warm up the oil. It will get the settlement particles out of the engine and also make it flow out easier if it's a little bit warm

As a protip from someone who spilled a lot of oil the first time I did an oil change on this model, you can use an old milk jug sliced in half longwise to guide the oil away from the frame. Saves a ton of effort with clean up. There's an official part for it but most of the reviews say it spills. And why would you pay $20 for a piece of plastic when a milk jug will do a better job for free?

Just got the same mower yesterday. Thanks for the tips. Gives me more piece of mind

Helping me with stuff my dad isn’t around to teach me. Can’t thank ya enough

when changing the oil, you can take a bottle of your favorite soda, cut the top so it fits underr and around where the oil runs out, cut the bottle of the bottle so it flows out into what ever container you want it to go in...and go forth young man and make no mess

For the motor visibility You can remove the hood cover, pull it up and you can plug it back in when done

A secret B&S engine tip, use an oz or two of Lucas oil stabilizer in fresh oil. Runs smoother

It comes with funnel that attaches under plug to give flow a direction.

I've always siphoned my oil out of my mower....no mess at all. Thanks for the video.

Always check owners manual before any maintenance procedures. Also it helps to invest in a spark plug wire pulling tool to remove the wire to the plug, saves knuckles and cuts from happening 😊

Thanks very much for a great video. It covered all the information I needed for my T100 tune up!!

48 ounces is what the Brigg's chart calls for total capacity.

my T100 came with a little trough to put under the oil drain to guide the oil past the frame....comes in handy

Tip = Small aluminum foil trough for the oil...

This was an awesome 👏 awesome video, thank you for posting this. I really appreciate it.

Great job, I just purchased the same machine. Thank you

Good video, what was the #number for the Genuine air filter.

Why didn't you remove the hood? It is made to come right off. Easier when changing spark plugs.

There is a oil spout that comes with the mower to drain oil directly into the pan . But enjoyed the video

Exhaust shouldn't be hot. Change spark plug ONLY when cold

I would have liked to see how you jacked up the mower enough to change the blade. I don’t want to take off the deck. But don’t know how to lift it up to get under it with ease.

Can you do a quick video showing where the fuse is located? My mower won't start and I think it's the fuse. Thank you

That steering bar on the right needs some re-engineering to make the oil change not so messy.

How many ounces of oil for the T 110 ?

I always have waited 5 minutes before checking level of fresh oil

Sorry if already posted but there’s a drain sleeve for draining oil

My T110 battery is draining while the engine is off. I am told to check the regulator. But I do not see a regulator or a rectifier. How is the AC converted to DC on this mower? Please help

Just to top it off if needed

I know this video is a few years old, but i have same mower, where did you buy the blades at?

I've got a new to me used t100 it's making a grinding noise in the rear what should I look for?

I put a extension pipe on my mower that sticks out past the frame works great no more mess cost $3

What type of oil goes into this type of lawnmower

You never sharpen the new blades I never saw uou change the oil filter why

Helping single ladies do it!

Didn't see you grease anything

B & S manual says SAE 30. Not 10W - 30

Is there a washable filter replacement

Why is there no oil filter on this motor

Are there no grease zerts? Don’t gotta line the bearings etc?

It calls for 48 oz.You put way too little

Release brake

This mover don't have oil filter

So basically he gave it to you unbroken and now you broke it.

This guy is an amateur ! Why not run synthetic oil? Don't take his advice.

Release brake