Kent VanderVelden happy thanksgiving to you tooooo.

Had to prove that it worked before we build a rapid turn for the table. 4 axis coming soon. Thanks for watching. Please share the video if you have time.

Dan Nichols probably could have for these parts but what if they are bigger that what i have a collets for in the future so we decided to just go ahead and figure it out the right way now. Thx for watching

Norbert St. Pierre well all i done was turned on the spindle and ran the sheave as slow as possible and then put it in low or backgear. Then I tried to turn it with a 10" crescent and just about bent the tooling so I figured that was good enough. The square tool is in a round collet too. Lol. It all works great. The cuts have to be light tho it lifts the table on the mill if ya get to deep. We ran all four parts in just a few mins so the light cuts don't bother us much. Still better than standing there running it by hand.

TheJR914 shars carbide insert tool round

John lambert Finish looks great.

TheJR914 thx that round insert done such a nice job it didn't take much to polish them up. Did ya get ur mill going??