Parameters depend on the nature of sample. You need to play with different parameters at first. Try with different blot time at first. Vary between 1 and 10 sec . Then try changing blot force. Sample amount is about 3 to 3.5ul. The trick in the transfer is that you need to have a stable hand during transfer. Rest your palm on the cup, release tweezers and then transfer.

Thanks very much for the video!! Its very helpful!

how you can set the lot time and blot force ? what are the parameters we should keep in mind to set these values?

Now I know why it didn’t work for me. I forgot to faster the cooling……

3:28 4:43 6:22 6:32 6:51 7:47

You didnot put anti-contaminator (a float ring on LN2). Why?

Great video. One question: When you take the sample out of ethane and into the liquid nitrogen, can you dip the tweezer in the liquid N2 as well? If you dip the tip of the tweezer too much, there will be bubbling because the upper portion of the tweezer is still at room temperature and I wonder if the ice will be formed on the sample because of this. I cannot see where your liquid nitrogen level is, so cannot be sure what you did at this step. Thanks!

welcome :)

It helps a lot. Thanks.

hi, could you give me the diffrent paramaters you use: Blot time, bolt total, blot force and the quantity of liquid you put on the grid ? And do you use a special trick to transfer the grid from the ethane to LN2 ? Thx a lot

Will this help me sneak dinosaur embryos out of the park?

you welcome!

Vitrobot FEI

Hi everyone.If you read this message please read the Holy Quran the direct words and the final message from Almighty God.It will guide you to peace truth and happiness in this world and the afterworld with my lovely wishes