You are welcome, God bless you too

Herson Cruz is in it easy to use blessing port? Just push it and that is all.

My problems are exactly the same what was the issue?

Mine is liking from the side in between the hole thing

Looks like prime pump

Ecm maybe bad I had the same problem changed ecm appears to be working fine

Did u figure out what was wrong with it?

Судя по описанию, нет топлива в системе, проверить надо сначала есть ли топливо в фильтре, и работает ли прайм помпа и потом по цепочке до самого насоса.

Не совсем понимаю в чем может быть причина, заменил 2 насоса, обратный клапан, соленоид, а давление не поднимает выше 30, зачем все менял не понимаю, на старом все также было. При нажатии на Верхний сосок для сброса воздуха, идёт топливо. В чем может быть причина, и какое давление должен создавать подьемный насос(после замены не изменилось около30)

@@stant1909 давление маленькое ? И не заводится? Или что? Где мерят давление ?

easy, just change fuel level sensor, it is stock

i changed the fuel level in the fuel tank. it still does not work. What else do I check?

No

Try check fuel rail pressure sensor- looks like fuel pump can’t stop when it’s supposed to stop.

Did you find the check valve?

@@tiorobot I found one finally and replaced it . After doing some research on how this engine self primes , I’m not sure if it was ever really an issue . I replaced the check valve and each time I start it up I let the fuel pump prime for about 2 cycles . It starts right up . I’m gonna let it sit for a month or two and see if it has issues .

@@9caplad good deal. I wasn't sure if you had found the check valve or not. It's ok a little tricky to explain where it's at.

@@tiorobot I went down to the international dealer to look at a parts diagram .

@@9caplad it's always nice when the dealer or someone with knowledge lets you look at things like that

What was it?

pinchi wey I have the same issue did you found what it was

Primong pump not working

*find

What was the problem because l have the same problem.

Long cranking time

Peter Alfaro yes, it possible prime pump went bad

Dmitry Egorov just replaced, hopefully that solves it. Thanks for your input

@@Poepetee what's up Peter did you ever get the truck fixed with new prime pump.*?

@@Poepetee or was it a different problem. What you described in your post. My truck is doing the same thing. But now it doesn't start at all. It just keeps turning over and doesn't start at all.

Seriously

Start with changing fuel filters.

if international prostar check Relay that works with battery

Rana?

We’re is the relay location???

Kanat Abdykerimov для начала надо поменять все топливные фильтра. Потом проверить если праймпамп работает, вкл зажигание и при открытом капоте слушать если насос работает - должен быть громкий звук как насос качает топливо.

Фильтра поменял ,звук громкий походу работает памп, а могут быть причина с топливного бака ?

Если прайм памп не работает трак вообще не должно заводится ? Или может

Kanat Abdykerimov Из бака идёт в стеклянную колбу -фильт от туда прайм качает через железный топливный фильт в инжектора.

Kanat Abdykerimov если прайм не работает, заводится будет, но крутить стартером дольше, т е дольше заводится.

caner sekmen need more information to help you.

Dmitry Egorov 🙏🙏🙏 Diagnos also pump pressure full, km 700.000,new injectors loading but problems not in injectors😢timing valves repaired...The elements in have changed..I don't know if it works?very short time there was very little improvement...normally hard and strong engine now runs very quiet and weak...black smoke between gears would do no more room...there was a very nice sound that has no exhaust😢

Dmitry Egorov pedal responses too weak ... especially in cold weather the first starter works very hard, now it is not

Dmitry Egorov injector and valve settings new, check valves intact, centrifugal intact.and no injector sound,no force,fuel consumption increased... Please help me i cant work,working very hard and seddy it's not like it's no more than 420 hp 370

Dmitry Egorov my mind gets stuck in ecu and timing actuators..