Cup Chucks for Turning Spheres

Рет қаралды 5,025

2 жыл бұрын

Mike Peace demonstrates turning some simple cup chucks for turning a sphere between centers.
My video on turning spheres with a jig • Sphere Cutting Jig in ...
My video on turning Wood cone centers • Turn a Cone Center for...
As an Amazon Associate I earn from qualifying purchases from my Amazon shop www.amazon.com/shop/mikepeace...
You can download demonstration handouts, downloadable copies of articles I have published, and other useful woodturning information available on my website www.mikepeacewoodturning.com/

Пікірлер: 21

@jackthompson5092 2 жыл бұрын

Great video Mike.

@lostwithlukee Жыл бұрын

SO HELPFUL

@glencrandall7051 2 жыл бұрын

Good information Mike. 👍👍Thanks.🙂

@MarklTucson 2 жыл бұрын

Great illustration of the chucks and how they make contact at the end. Thanks

@KTankerous 2 жыл бұрын

Thanks Mike, very interesting!

@benniegreen498 2 жыл бұрын

Very informative and the manipulative models very helpful. I am going to make some jigs to turn spheres! Thank you👍🏽👍🏽👍🏽

@MikePeaceWoodturning 2 жыл бұрын

Go for it!

@davidmorgan7522 2 жыл бұрын

Great idea Mike! Simple but very effective. Thanks for sharing. Take care, Dave

@MikePeaceWoodturning 2 жыл бұрын

You bet!

@radiationroom 2 жыл бұрын

Another informative Mike Peace video! Thank you for sharing!

@hfbowerndesigns810 2 жыл бұрын

Thanks for sharing Mike. Good set of holders, now I just must try make a sphere😀 Take care my friend Cheers Harold

@MikePeaceWoodturning 2 жыл бұрын

Easy peasy. No jig or math required.

@oatkeroder 2 жыл бұрын

You all of a sudden taught me something else Didn't understand how to use dividers to estimate an inside diameter. Just listening closely you explained it to me. Thanks again. You keep teaching, I'll keep learning.

@MikePeaceWoodturning 2 жыл бұрын

Thanks for that feedback.

@rayswann9080 2 жыл бұрын

Thanks for that one Mike. Watched it a couple of times to make sure the detail sunk into the grey matter. Am making a sherical resin night light for my grandaughter and the mould leaves a ring around the circumpherence so I was looking for a way to spin it for polishing this off and along come your timely vid. Cheers

@MikePeaceWoodturning 2 жыл бұрын

Cool!

@thesweetone 2 жыл бұрын

Thank you, this is exactly what i need! :)

@jessetutterrow4320 2 жыл бұрын

I never used a cup chuck. Thanks for the information. You mentioned that too small of a chuck diameter has problems, is there a general rule of thumb relating the sphere diameter to the diameter of the hole in the chuck?

@MikePeaceWoodturning 2 жыл бұрын

No rule of thumb I know. Too small does not hold. Too large and you can't cut as much surface and need to reposition more.