ThatsCoolWire.com - Presents a great video on answering the question can you cut Our Flat El Power Shapes. In this video we will answer that question PLUS show you a little trick when cutting the Flat El Power Shapes
Пікірлер: 18
@icenesiswayons99625 жыл бұрын
Thanks for sharing, I've had my EL panel for five years and have been scared to cut it until now. Thanks again
@amikhimji10 жыл бұрын
Great video thanks
@LittleRubyRue11 жыл бұрын
I am considering using el tape for a costume, however the tape will be wedged between two layers of cloth (the whole idea of it is for the light to shine through it and be a surprise) anyway since the el tape wont be visible to the naked eye in natural light would it be wise to just make detailed shapes by sticking black tape on it? instead of cutting it?
@TheFinalformsora11 жыл бұрын
is it possible to cut wedges out of the tape and then reconnect the remaining pieces to get a curve? i'm planning out a prop and i dont have much space for battery packs so it's better for the deisgn and cost if i can use tape instead of sheets.
@s13b879 жыл бұрын
is it safe to layer a stenciled sticker over the panel? like to create a sign out of it.
@COPY_CAT_985 жыл бұрын
I have a question with EL wire can you add LED lights at the end of them? And both of the two lights work?
@MetalVikingBatmanfan198911 жыл бұрын
if the EL Tape comes by metre can i cut the copper type bit on it if i was to cut it at the end of the tape leaving enough so i could have it at exatly 20cm
@robertmartinez2072 Жыл бұрын
Do you know how to curve the el panel??? Like make them almost round
@themoneyiscalling6 жыл бұрын
Is there a possibility to make a circle that's 2cm or smaller?
@sheanrodrigues710 жыл бұрын
are these light waterproof?
@sniffy26149 жыл бұрын
can we cut EL panel with CO2 laser cutter?
@rockman3073 Жыл бұрын
Have you tried this by any chance?
@sniffy2614 Жыл бұрын
@@rockman3073 no
@Daxter60910 жыл бұрын
Don't you have to put tape around the holes you punched?