Cylinder 1 Misfire P0300 P0301 2015 Dodge Durango

No video

Cylinder 1 Misfire P0300 P0301 2015 Dodge Durango

Рет қаралды 9,886

Күн бұрын

Ended up being bad spark plugs, just replaced them all.
Buy spark plugs here: ebay.us/R8MMrh
Buy intake gasket kit here: ebay.us/jjW85Q
Buy goggles here: s.click.aliexp...
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network

Пікірлер: 14

@thisguyshorty3554 5 ай бұрын

1st time Penstar owner. I saw a video on changing plugs. PITA!

@connorwilliams2335 5 ай бұрын

My 2014 Durango is making a knocking noise kinda how you described the Chevy cruzes I was thinking it was misfiring , which is why I was watching this vid but now that you said that about the spark plugs that’s probably the problem

@mohammadawwad839 4 ай бұрын

Does this work for 2018? Have a cylinder 5 misfire

@Tech-28 4 ай бұрын

Yes 👍

@valancesmith4617 11 ай бұрын

Where is the next video?????

@executiveshades 11 ай бұрын

Thanks for the video bro, So I'm having the same exact issue and code but only says cylinder 1 misfire so i changed out all 6 spark plugs and continues to give code after i clear and runs bad at different times then doesn't, Do you think motor is shot? or like a bad Cam

@Tech-28 11 ай бұрын

Did you try moving the ignition coil packs from cylinder 1 to cyl 3 and vis versa? Also could be a roller failure on the camshaft, seen those go bad a lot

@charlieboy501 8 ай бұрын

Could be the coil

@ssclonesilverado5606 5 ай бұрын

I have the p0301 code and have some shaking while on idle, would changing spark plugs and coils fix that issue?

@Tech-28 5 ай бұрын

It could, but you would have to either diagnose it yourself or have a technician diagnose it to be 100% sure. If you are able to have someone scan it and erase the fault codes and then mark and move the ignition coils around to different locations, if the same code comes back than you know it’s not the coil, if it’s the cylinder you just move coil #1 too than you know it’s the coil