Degree123456 control point curves for the artist.
Рет қаралды 1,103
Күн бұрынThis video gives a basic understanding of the degree of your control point curves without all the math and technical explanations.
@modelenginerding6996 2 ай бұрын
Very helpful, thank you.
@philprocariojr3563 2 ай бұрын
You're welcome, I'm glad it helped.
@Fasimedes 2 ай бұрын
Awesome! please make a "single span" tutorial :D
@philprocariojr3563 2 ай бұрын
@JoseMendoza-mc8ic I just uploaded the first video on single-span curves and hope to make one on single-span surfaces soon.
@MatheooPL 2 ай бұрын
awsome! what is the difference between "raise degree" and "subdivide" command for a curve in Plasticity?
@philprocariojr3563 2 ай бұрын
@MatheooPL I'm not sure about the technical difference. When testing both, you will notice that they raise the degree by 1, but they do it differently, and I'm not sure exactly what that is. I'm getting an answer to this question now, though, and I will let you know what I find out.
@philprocariojr3563 2 ай бұрын
@MatheooPL Nick Kallen got back to me on this. Raise degree does exactly what it says and subdivide adds spans. Spans - sub sections of the curve. Higher degree curves will have fewer spans (for a given number of CVs) and a greater degree of smoothness between spans.
@MatheooPL 2 ай бұрын
@@philprocariojr3563 I get it now. Thank you very much!
@baril3d 2 ай бұрын
@@philprocariojr3563 By this I assume it would then be best to use the raise degree command for smooth surfacing? Great video by the way
@philprocariojr3563 2 ай бұрын
@baril3d Actually, the degree of the surface is not what determines its smoothness. Higher degrees just allow for tighter bends in the surface. (More curvature)
Phil Procario Jr
Рет қаралды 420