Love it. Thanks 😊 for sharing

I like it.wally.

Love to see it hit the water brother! Be careful with that needle my friend.. For sure get that motor higher.. try center of the bullet 1/8" higher than the rear inner edge of the sponsons.. your original needle setting was probably pretty close to where you need to be for right now.. Definitely get rid of that 440.. I wouldn't bother to much with props unless it's a x637 or a reduced x640 to 38mm.. think I sent you some sholund props? I can't remember.. I know they are much more finicky than gassers.. but stick with it, when it steps up on the pipe you and the tt should be quite happy...😎

Hello everyone...when I got the boat home I removed the tuned pipe and found I put some sealant around the silicone coupler and it blocked the exhaust flow...cleaned it out and got the correct coupler for the engine/header..much better results

Super 👍

i like to see scratch build. 1 too many blades on the tunnel. save that prop for mono . also prop nut too big