Informative video. بہت خوب

Ld formula not correct...check the formula from clause 26.2.1 IS code 456:2000 . (Dia x 0.87 x fy / 4 x Tbd)

i well understand your video. Thank u very much our engineer...

Very helpful video and bhaijan you are looking beautiful

Sir Why lapping length not provided if reinforcement dia more than or equal to 36 mm

Good lesson I well understand

Good work

Nice video

Sir u r pronounce is Soo good ..

Thank you 😊

Thanks for the lesson. Great

Could you make a video explaining where (how far apart) the pillars or the columns would go on a three-story house that’s 5 m x 5 m. Thank you 🙏

Excellent explanation thank you

Thank you our engineer

Very short and clear Thank alot

Great 💪🏿 A million thanks

Its good

Explanation is good laping length how many ft

Great videos my brother .... in Longitudinal rodes (vertical bars) do the development beam connect to ..... does it connect on the bar next to beam or it connect on the middle bar or it connect on the outer opp bar (assuming a column is a 8-point bars )? 🤣🤣

But you told us in the formal video that dl= 0.42D where D is depths of beam but now you said is 0.87y/Tbd

For different grade of concrete, we have different bond stress, Tau bd

you are so smart thank uou

Sir u r pronounce is special

Thanks engineer

I have some doubts, As we practice on site as per the drawings... The development length is the total length of L shaped bar, start from the face of the column and beam, but you told it's only the bent portion of the rebar in side the column... Please clearfy.. And it's not a constant value it varies with the grade concrete.... In general we use 50 d... But you told 18 d???? Please

Sport bar means?

Thank you Sir 🙏🙏

Thanks sir

Aoa sir your videos ar usmd ful sir kindly tell us about coĺumn nd beam in basement 35*40

50d lapping length provide in all cases?

Assalamualaikum sir ap urdu ma b video bnaya kren kindly

Sir 0.87 but is456 is not be used

16 x12 =192 mm =8 inches which is less than 12 inches..I guess something is missing here...or u have not calculated some factor. Thnx

How do you calculate Tbd ?

How many inch for lapping lenght

What is bond stress

very helpful but sir instead of writting plizz used computerised spellng

Other ...atherrr

In development length formula what is the constant 0.87.

loping length draw only calculation show's to draw

What is is456

Why good by ? Should Allah Hafiz. From Bangladesh.

Writting font is too small

45d from IS:456 2000. CLAUSE PLEASE

D0. 87fy/4 tbd

Not satisfied