you need to connect the ground pin at the preamplifier input to the minus on the board's power supply
@osamaanwar1277 Жыл бұрын
Use one single chip NE5532 or JRC4558 on the output side and on the input side do not use a chip just short the pins 1,2 and 6,7 on the chip base, that will make the noise go away.
@wzildjian Жыл бұрын
Do you make this? Do you have any audio gain?
@Centar19642 жыл бұрын
DK125 is not a op-amp chip, it is for power supplies...they installed the wrong chips at factory. Get it refunded.
@johnbravo7542 Жыл бұрын
I ordered a preamp board,not the same as yours,it had a fake ne5532 chip,replaced the chip with a genuine one.
@juanguerra8361 Жыл бұрын
Thanks, it should work!
@martinsinvestimentos62972 жыл бұрын
Entra é 12v até 24v Troca o ic 5532 liga ele em 20v ou 24v eu liguei na fonte de notebook 19v é funcionou meu tava assim
@martinsinvestimentos62972 жыл бұрын
Voltagem está investindo tenho uma também não funciona só barulho 🤦🏻♂️
@ahmadfaraz33462 жыл бұрын
Brother you need to replace DK125 with NE5532P and it will be ok. Mistakenly the manufacturer has inserted the wrong integrated circuit. Is it clear now ?
@juanguerra83612 жыл бұрын
Thank you dude! it Always has been clear for me.
@mboyslost9802 жыл бұрын
Ton conrolnya jelek dengung yg blm beli saran saya jgn beli ton ne 5532