Discover the secret to accurate bolt load calculation

Рет қаралды 3,112

Күн бұрын

Scootoid elearning | Bolt Load Calculation| Mandatory Appendix 2| Gasket factor | What is seating stress | Minimum Stress Required in gasket for proper sealing | #ASME, #PressureVessel, #Engineering,
#Training, #Calculation, #MechanicalEngineering, #CodeCompliance,
#PressureDesign, #Welding, #Fabrication, #ASMECode, #PipingDesign,
#PressureVesselDesign, #MechanicalDesign, #EngineeringTraining
#PressureVesselCalculation
Static Equipment design training as per ASME SEC VIII Div1, PV-Elite Software training, Storage Tank Design training as per API 650, TEMA Standard
*******************************************************************************
Courses Available:
-Master, Pressure Vessel Design, as per ASME SECTION VIII Division 1 training.
-Master, Tall cylindrical tower, or Column design training.
-Master, Heat Exchanger Design, and TEMA requirement training.
-Master, PVElite software training.
-Master, Storage Tank Design, as per API 650 training.
*******************************************************************************
eLearning Platform for our courses which are available here :
scootoid.think...
Learn more form
forms.gle/8mVV...
WhatsApp No
+91 89288 65726
+91 79779 40765
Schedule an appointment with the trainer
calendly.com/a...
*******************************************************************************
Subscribe
/ @scootoidelearning
Learning Management Platform for Static Equipment Design:
scootoid.think...

Пікірлер: 9

@Roman-kn7kt Ай бұрын

Thank you!

@jasonligo895 Ай бұрын

I would think that adding Wm1 and Wm2 would be the total force that the bolts would need to exert in order for a gasket to not leak at a specific operating pressure?

@danielodeliro2412 Жыл бұрын

Thanks

@lostinlife5154 Жыл бұрын

Abhishek Sir... I wanted to ask why value of "m" is > 1 I mean how gasket can apply more pressure on flange than it is subjected to. I mean if internal pressure is 5 kg/cm2 how gasket (having m=3) is applying 15 kg/cm2 ? Logically it should damp some pressure. Right ?

@shridharjakhalekar5002 Жыл бұрын

Why there is multiplication by 2 in Wm1 but not in Wm2?

@majidalkhayari5572 5 ай бұрын

I do not understand from where the 2 came in Wm1 eq but I do understand why it is not there in Wm2 eq. G×pi = mean circumference of the gasket so when he turned it into a rectangle it became the rectangle length. b is gasket width, practically it is OD-ID of gasket if I am not getting this wrong

@ManojKumar-vf4gf 3 ай бұрын

2 faces of the gasket

@atishjain7093 Ай бұрын

No 2 gasket faces does not means 2 times force will be taken. Reaction force always be there.

@danielodeliro2412 Жыл бұрын

Thanks