If Everything Works Fine It Is Not necessary but if There are Troubles then I would program It If I were you just try and see 🙂

I don't know, the dealer can tell you that instandly. Have a nice day greetings From Holland 👍🏻😎👍🏻

Kan ik zo niet zeggen, Ik weet ook niet precies hoe het schema loopt maar als ik het ontworpen zou hebben zo denk ik dan meestal maar dan zou ik dat via twee relais laten lopen en dan moet je dus gewoon de stuur draad vanaf de Sam Module nalopen. Als rechts een massa krijgt en links niet, zou je tijdelijk de stuur draad van het dimlicht links bij aan de rechter kunnen knopen, gaat dan links ook branden dan is de Sam inderdaad de oorzaak...

Adding to that, when I am diagnosing the sam module with diagnostic tool, the light on button works, butnitnstill doesnt engage the relay

Hi Erik, i cant tell sorry.

Yeah Noel i have: Folow the video, or send sam to me..😇

@@rickstevens2941w368 vito have that module too? When i turn on the ignition a buzzing sound coming from the steering collumn, and that noise when i push the hazard button. Any ideas?

Sorry i don't @@noelszabo1291

Sorry i don't know, First thing to do is: check The Car with Star diagnostics.. That's the best entry to go. Good Luck. 👍🏻

@@rickstevens2941 U0423 Invalid Data Received From Instrument Panel Control Module ha ezt jól értelmezem akkor a motorvezérlőtől nem kap a műszerfal megfelelő adatokat. Vagy a müszerfal nem jó és nem tudja feldolgozni az információt.

U0423 Invalid Data Received From Instrument Panel Control Module if I understand this correctly, the dashboard does not receive the correct data from the engine controller. Or the dashboard is not good and cannot process the information.

Sorry For My late response depends on Which Turn Signal

@@rickstevens2941 thanks very much for the reply. It is the left turn signal. The green left arrow flashes quickly on dashboard indicating that there is a fault and none of the left turn signal lights flash on the exterior of the van. Thanks again for your help 🙏

Yes than there is a hi side Driver in de Sam module Broken see mij other clip on youtube kzfaq.info/get/bejne/np6posV6v5ilh6M.html This is Sound of the same Problem but it's not a Vito

I think this Will leed you in the right Direction: kzfaq.info/get/bejne/np6posV6v5ilh6M.html

@@rickstevens2941 Thank you very much for your reply. I just watched the other video you suggested. I think this is just for the turn signal at the front of the van? The problem with my Vito van is. that all of the turn signal lights are currently dead on the left side (back, side and front) of the van. Will this component solve this issue? Also does this component plug in to the SAM module? Sorry for all of these questions, I really am very grateful for your help.

Hi Dean: replace the part and your problem will 99% sure be fixed 😉 and be Blessed 👍🏻 ( in this case the high side driver is shorted )

@@rickstevens2941 I thank u what part must I replace Dean

Sorry For My late response.

I'm Lucky I don't have to do this all day,😉 But yes I always keep them Up 👍🏻😎👍🏻

Hi Rick what part must replace. The problem is I connected n trailerlast Weekend n left side indicator was blinking fast in vechicle n outside bt then it stopt blinking outside stays on permanently bt blink fast inside What part must I replace Dean thanks South Africa