STL- fab365.net/ite...
GOODesign has completed a display stand that allows me to display my Foldable F-14 more beautifully.
Since the plane was so big, the stand had to be bigger as well. However, careful modeling was added here and there to prevent it from appearing too large visually. These include an A-shaped hole with a hole in the center and a negative sculpture with a sense of speed on the side.
1. When inserting the F-14, insert it from the back and then support the center of the front.
2. When removing the landing gear, twist it slightly outward and it will come off easily. However, if the weapon is attached at the wrong angle, the landing gear may not come off easily, so be careful when attaching the weapon.
Hope you can display my masterpiece, the F-14, with this display stand.
Learn more about this model at fab365.net and watch the longer assembly video!
Largest part in printing, size= X 125mm, Y 198mm, Z 154mm, After full assembly size= X 125mm, Y 200mm, Z 215mm
Total Build Time : 32h 10m / Plastic Weight : 213g