DIY Audio Amplifier Design #1

DIY Audio Amplifier Design #1 - Failure!

Рет қаралды 710

15 күн бұрын

In this video, I go through prototyping of an audio amplifier using LM386 Audio Amplifier IC and fail miserably. Lets start a project to design something half decent!
If you have any questions or feedback, please let me know in the comments below.
If you want to join a fledgling community to discuss anything, consider joining my discord community at:
/ discord
Like, subscribe, and hit the bell to stay tuned for more educational content. 🚀
#Electronics
#CircuitDesign
#audio
#LearningElectronics
#Circuits101
#ArtofElectronicsSolutions
#AoEExercise
#ArtOfElectronics
#ElectronicsTutorial

Пікірлер: 6

@glasslinger 11 күн бұрын

The thumping of the batons on the instrument is going to be a problem it looks like!

@TheEngineeringExperienceYT 11 күн бұрын

Just not enough output from the speakers so mic is only picking up the mallet strike sound. The audio amplifier helped a little bit but nowhere near what I was expecting. I am designing (and making a video on) class d amplifier. Hopefully that works better!

@MrDawen1997 10 күн бұрын

What about putting a 4 ohm resistor in series with the speaker? Because I heard that 8 ohm speakers are better to drive

@TheEngineeringExperienceYT 10 күн бұрын

Thanks, I'll try it out. The datasheet does say it can drive a 4ohm load but who knows.

@glasslinger 10 күн бұрын

@@TheEngineeringExperienceYT Something I learned in my 35 years as an electronics engineer is to KEEP THINGS SIMPLE! Build something simple and conventional. Class D amps are a complicated mess to get going. Not recommended without lots of experience and having instruments to test the circuit.

@TheEngineeringExperienceYT 10 күн бұрын

I completely agree about keeping things simple. This is a learning thing for me so I am "experimenting". I am going to try make the LM386 work and build a class D (not from scratch but from an IC). Thanks for the feedback.