DIY: CV Axle replacement on Range Rover L405 and Sport L494 2013-2021 (Complete Guide)

Рет қаралды 26,757

2 жыл бұрын

Step-by-step through the process of replacing the CV axle on a 2013-2020 Range Rover.
I WOULDN'T RECOMMEND BUYING TRAKMOTIVE CV-AXLE!!! POOR QUALITY PARTS!!!
Looking for a European car specialist in Southern California? I can help!
Click the link below to get a quote now!👇
app.shopmonkey.io/quote-reque...
Don't forget to subscribe :) Thank you!
Any help would be greatly appreciated🙏 www.paypal.com/donate?busines...
Disclaimer:
Due to factors beyond the control of Land Rover Tech, I cannot guarantee against improper use or unauthorized modifications of this information. Land Rover Tech assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Land Rover Tech recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Land Rover Tech, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Land Rover Tech.
#LandRover #RangeRover #l405 #l494

Пікірлер: 60

@Alexfixty 20 күн бұрын

Hi! I provide mobile car repairs for European vehicles in Southern California. Request a quote here👇 app.shopmonkey.io/quote-request/e4c56803325fda668f1050eca12fba84?noExternalScripts=1

@rickgarza265 2 жыл бұрын

Man those disconnections looked quite strenuous, but I’m sure you saved about $1500 of repair cost that a dealership would charge… thanks for the video

@ghobrialmichael7522 2 жыл бұрын

Thanks for making this. So helpful! Can you do a transmission fluid and rear diff oil change video?

@Blabla-wm2km 2 жыл бұрын

This is super important contribution

@ozzy1964osborne 2 күн бұрын

Great work, thanks for the video, keep them coming

@jonathanpinkett5439 2 жыл бұрын

I respect how hard you work. The questions about a torque wrench will keep coming for sure. Great videos !👍

@user-ym9wb2mk5e Жыл бұрын

Thanks for the video. I bought my replacements at Rock Auto. Their site states single speed transfer case, but they will work on the two speed units. I called the manufacturer and they verified the PNs. These are for the L494 - TRAKMOTIVE RV8017 and RV8020. My symptoms were metallic popping when turning left or right, on both of my L494 models. I also changed my oil with the proper Royal Purple type since I was already working on it also. Make sure to clean the magnetic bolt head from the case.

@user-wb8uu5jz3l 2 жыл бұрын

Great job~~. Super helpful to me~. Thanks..

@ivomarkoff 2 жыл бұрын

Hey, welcome back!

@bobs.3346 14 күн бұрын

Thank you for this video, very helpful!

@Alexfixty 11 күн бұрын

Glad it was helpful!

@TheVLADROCKSTAR Жыл бұрын

Good work bro, keep it going

@vincehenshall9824 3 ай бұрын

Very helpful video. Just replaced mine, wouldn’t have done it without watching you do yours. Thanks

@Alexfixty 3 ай бұрын

Cool 😎

@bigtime4701 Жыл бұрын

Your work is precise, Can you do a video on replacing the rear hatch struts on a range rover L405? THANKS

@ai_am2923 Жыл бұрын

Good work 👍 thank you 👏

@jansharawan1358 3 ай бұрын

Good work baro

@MS-ek6yc 2 жыл бұрын

I love watching your videos, but I have a question has nothing to do with this video. What is the sensor under the plastic cover on top of engine that says supercharged, mine (one of the cables is cut) and check engine light is on. Thanks

@ianbailey4114 Ай бұрын

Thks another great vid

@Alexfixty 11 күн бұрын

Thanks again!

@diffmazurek640 2 жыл бұрын

Would appreciate more clarity on how to pop the axle out from the retaining clip. Also not to overextend cv joint to make sure it stays together

@carana2002 4 ай бұрын

Great job, what about the torque specs ?

@terrythurston8572 10 ай бұрын

Same model. I think I have a bad wheel bearing , was thinking about disconnect brake calibre and drive shaft , that would allow me to spin the hub without any drag. What do you or any other folks think .?

@cristianabreu7797 2 жыл бұрын

My 2017 is vibrating from the driver side with 36000 miles only can that be ball join or cv axle. I notice is doing a movement while putting the vehicle in reverse also makes a clunk noice.

@trentbanks2134 Жыл бұрын

Hey, alex I've have a telematics issue that say Limited availability. 2017 range rover supercharged

@barrthom603 Жыл бұрын

Can you share a link for a CV shaft you recommend? I cant find many options online to buy a replacement

@chessguru900 8 ай бұрын

Is it necessary to remove the whole drive shaft to replace the outer cv boot?

@user-ul5tj4mt3e 4 ай бұрын

how do you take out the longer end on the other side? do you need to remove the whole knuckle or just the suspension bracket?

@startingtech3900 9 ай бұрын

Bro now my passenger axle went out. It expelled grease all over outside of the boot and only makes a grinding sound when. doing right turns. Also clicking like you mentioned. Thanks for this alex.

@Alexfixty 9 ай бұрын

✊✊✊

@copperoutletghosttown3283 4 ай бұрын

Please explain what noises, clicking, symptoms that told you that the CV Axle was bad!!

@dennysmoreno8150 4 ай бұрын

Thanks

@user-ym9wb2mk5e Жыл бұрын

Trying to replace this on a 2016, already replaced them on another RR, this left side appears to be rust welded (axle splines to axle bearing sleeve splines). I am thinking the factory didn’t line the splines. Yours popped out just fine…..

@Alexfixty Жыл бұрын

It took some effort tbh

@remotelearningpsu7915 Жыл бұрын

You do good work! You need some better tools though.

@danimager 2 жыл бұрын

Hi, Thanks for the videos. They are really helpful. However I need some help. I am desperate. I have a 2015 l494 3.0 SDV6 and I have a vibration on the steering wheel and sometimes in the seat too. Happens around 35-50mph and is there around 80, but there I can hear it more than feel it. I have changed the propshaft, both axle shafts and also transfer box. Vibration still there. With each the axle shaft replaced vibration seems to be smoothen a bit but still there. Starting uphill only with tires turned out at least more than half way out there is a low crackle sound. Can it be the front diff? Thet is my last suspect. I fear to change it and still have the vibration. Thanks.

@paulwatson255 2 жыл бұрын

Do u have factory wheels or rims

@danimager 2 жыл бұрын

@@paulwatson255 yes I do

@paulwatson255 2 жыл бұрын

@@danimager do u have big off market rims or the original aluminum wheels factory wheels on it

@bobdaja 2 жыл бұрын

Did you have to drain the transmission oil to remove the drive shaft please?

@Alexfixty 2 жыл бұрын

You don't have to

@bobdaja 2 жыл бұрын

@@Alexfixty Thank you

@cesarblanco Жыл бұрын

Nice video. I would prefer refurbish the genuine axle. It's not difficult, there are plenty of videos, and for sure the quality of the part is much better than the chinese.

@Alexfixty Жыл бұрын

Great point!

@poppyboysgarage1518 2 жыл бұрын

Hard to understand why you don’t use a torque wrench for proper values, at least for the suspension components and axle nut.

@cristianabreu7797 Жыл бұрын

I have a 17 Land Rover Range Rover I notice to much movement on both front shaft cv axle ! 🙄

@startingtech3900 9 ай бұрын

Alex just curious bro what you meant about this brand was “poor quality “ what did you not like about it ?

@Alexfixty 9 ай бұрын

It was clicking sometimes after installing

@startingtech3900 9 ай бұрын

@@Alexfixty damn dude right after lol 😂 I got an autoZone duralast gold lifetime warranty axle it actually looks like really good quality. I paid 130$ for it instead of 85$ for the cheap junk

@cristianabreu7797 2 жыл бұрын

What was the reason replacing the cv axle

@Brandonarmistead5 10 ай бұрын

It was making noise while driving and going over bumps

@duncanreid854 Жыл бұрын

How long did you take to do this? 2hours?

@Alexfixty Жыл бұрын

Yeah I would say so

@duncanreid854 Жыл бұрын

@@Alexfixty Thanks. How’s the Chinese replacement holding up?? Genuine part way too expensive.

@elyorhoja Жыл бұрын

9:30 Lying underneath the car which is lifted on jack stand, and lowering it meantime - ??? are you mad

@Alexfixty Жыл бұрын

Kinda 😏

@BonVoyageExpeditions Жыл бұрын

Как они все надоели про торк рэнчь и jack stand. Молодец правильно всё делаешь. А то пол часа Ляля а дела ноль. Try to torque a that on the trail. He is showing a real life work or you all think dealer guys really torque stuff? I have every LR known, from defender 110 to Autobiography Black. Never have I torqued anything on them, never had an issue. If you a dumb aßs then go to Toyota. (They never brake, lol)