There is no BOM file in github, sir

Very nicely done and well explained. The PCB is well designed and looks as good as something that would cost hundreds. Thanks!

Man you did a wonderful job on this! I definitely want to build one when I get some time

Can resistors R4, R5, R9, R10, R14, R15, R19, R20 be replaced with 0.5ohm resistors?, or can they be replaced with other types of resistors that are easier to find? Thanks sir!

You may want to look at the INA228 it contains all the hardware needed to measure current and voltage plus it calculates power , energy and charge with high accuracy or for a pre built unit the Junctek KL140F saves having to write software to do it and they contain 20 & 24 bit adc's which alone would cost more than these devices.

What is the maximum current at 12v?? 8A too?? or 25A??

Very well done, especially the software is first class. It would be nice if you would reference the originator, John Scully more prominently. It's good to see that you fixed all the hardware issues that plagued his incemental design.

What power mosfets are you using?

Hello Dominik, great work🎉. I do have a question for you. There is a labeled pin as “OFF” in the schematics. Since this pin is same in every mosfet and controlled by 1 output pin so how do you calibrate each mosfet seperately? Thanks!

Terrific good looking DIY project, really neat. Congrats and thank you for sharing.

Reminds me of the Scullcom DIY DC Electronic Load.

Very nice!

Beautiful workmanship

Thank you for sharing. Your work uses basic circuits to achieve these functions. Even if the design lacks protection circuits, the project looks complete！

Awesome. A lot of work here! Good job!

You've earned yourself a subscriber! Great Job!

Awesome project, I love it ❤❤❤

Amazing work. Thanks a lot for share it

Great work!

excellent job. You should have more views and subs. Keep up the great work