if anyone wondering. for mk4 4m41 engine (3.2 diesel). the original solution from the web is to use 3.6k resistor but that was quickly rectified that in warmer countries a 4.7k should be used. get the 1W ones with 1% (not the tiny ones which are 0.1W). for 50pcs you shouldnt pay more than £6. it is basically untraceable if you will put isolation tape around it. a good check is to read the egr measurements through ODB2 reader (a cheap bt adapter is more than enough) before and after application

Legend, simple and clear.

Epic thanks. Subscribed for sure. Keep the knowledge flowing. Cheers mate 🤙🏼🤙🏼

Nice video thanks

Thanks for the great info yet again. I live in Far North Queensland, do you reckon that temp sensor will be right?

Gracias!!

Thanx for gr8 video, the other day I place that resistor on my pajero NS 3.2 147kW. So far car run smoothly but i notice engine became one idea noisy and keep little bit higher idle RPMs could it be from that resistor?

Ive read the Munji ones allow the blow off valve to funtion while allowing the EGR to remain closed on the way in. Is that the case of the resistor ones also? Additionally, would there be any issues if you took this in for a service and a mechanic spotted the fact that youve disabled your EGR

Nice one. Any chance of a delete pipe + temp sensors tutorial for the NS (for off-road of course)? Those DPFs can start a fire in the bush.

Hi buddy just wondering where your workshop is located,

Hi good vid , do you know the wire colour on a 3.5 GDI model , thanks in adt

Hello possibly going off subject here i have a 2007 pajero diamond gen 4 lwb 3.2 have started getting p0106 p0108 codes i have tried everything new map sensor new vac hoses inlet cleaned last year no blockages anywer egr delete dpf delete.. have ordered a new scv and new turbo solenoid have exhausted everything would you think of anything missed or overseen? Ecl light on and eml going to limp mode constantly any help greatly appreciated 🙏👍

Great works .. is there any affect/disadvantage on engine performance and fuel consumption ?

can u show us how to do dpf delete on ns pajero thank

Will it not cause the EML light to come on...

Does this work for gen 3, non common rails?

Will this work for a Magna?

Do i have to blank egr? With plaque

Does it need to be a 0.5w resistor or does 0.25w work as well? :)

What is the resistor??? Hardly understand…

where would i put a blank on my ML Triton 3.2 ?? I do have a blank with a 7mm hole in it ready to install

What wire would I fit the resistor to if I don't have a blue/black?

Is it very different for a 3.8L petrol Pajero (6G75)?

i did that now i get an engine light that i cant remove

This is for a 4M41 engine?

Hi mr pajero. How does this effect your fuel consumption?

I try but then 7000km, i think the liter pro mile is increase...

I did it and it threw EGR fault code

Do i have to blank egr with plaque?