DIY manual vacuum SMT pick and place

Рет қаралды 3,712

3 жыл бұрын

Пікірлер: 10

@Beobablish 3 жыл бұрын

A neat addition would be a foot pedal that locks the x-y rails so once you have the part in the right location you can ensure it doesn't move while you push it down into the solder.

@SeanHodgins 3 жыл бұрын

Very cool. Sometimes I'm fighting my shaky hands.

@graysong5787 3 жыл бұрын

No way, its the dude that made the cool 3D oled display. Your projects are sick!

@TheSeckmaster 2 жыл бұрын

How hard would it be to automate this using a camera and of course a bunch of logic behind it?

@graysong5787 2 жыл бұрын

A ton of work, I'd rather just buy a used pick and place machine at that point

@btAC242 10 ай бұрын

Hello! Can you more explain how the air is coming?

@M07RealKing 3 жыл бұрын

I like how you are using a full on 6654a to power an led lol

@graysong5787 3 жыл бұрын

M A X I M U M P O W E R

@ilikepie1974 3 жыл бұрын

Is this notably easier then just placing parts with say, tweezers?

@graysong5787 3 жыл бұрын

its easier when using both hands to guide the end effector. Where it really shines is the accuracy of placing a part, you can get it right where you want it. It also helps reduce shaking from my hands making it to the part. Also if you use tweezers you have to grab the side of the part, so if parts are close together you can accidentally knock other parts out of alignment when placing the new part because of the added width of the tweezer tips on the part