I can’t express how the vice really helped another project accomplished thanks, brother man

I took a trailor tire down to a Mexican guys tire shop and he showed me a trick and ones that won't seal,take a racheting strap and put around the center of the tire and rachet it till it seals then air it up.

Good thing I’ve been preparing by going to the gym for a year. I’ll be strong enough to just stretch the like you did I think. I didn’t know why I wanted to go to the gym but now it all makes sense. It was to change this tire!

Hey man I’m just a kid right now and I have a Baja warrior and I’m getting the same tire but for my back wheel was a pretty good bud keep it goign

Those beads were easy to break bud great information video brother heck ya

Going to give this a shot tonight. Thanks for the video, gives me hope I can pull it off!

They really went on easy - stay tuned I have a set of SunF Power.II 18x9.5-8 tires on the way

You the man thank you i just got mine done.

Need to do this without scratching them . Just had them powder coated

Leave the valve core out to seat the bead, then put it back in and air it up.

Thanks you very good working 👍👍👍

Alright so basically you need to acquire dad strength in order to complete it

How do you stretch the tire so easily🤯

man its a pain to get these stock tires off the rims theyre hella tight

Thx fam. Ur video helped

I put mine on the ground and stand on it pops right on

That must be some soft rubber. Mine are like concrete the rubber is so stiff

Question, When you ordered those tires, did the pictures for them show a different size tire? Thats what i'm experiencing

I never 👎 knew that popping a tire 🛞 bead would be so easy. These rims are mass produced, and usually not painted in the middle. I also find this on aluminum bicycle 🚴 rims, too. Ya want to watch for corrosion, especially on your rims. The Rust-Oleum is a great 😊 idea 💡. Ya should do it, if you’re running 🏃‍♀️ the tires 🛞 tubeless, and especially, if you’re going to use inner tubes. There’s nothing worse than corroded, or rusted rims. This literally fuses the tire 🛞 bead to the rim. In this case, it leaves 🍁 ya not much choice, other than to cut the tire 🛞 bead, or burn 🔥 the tire 🛞 to get it off. Sorry 😞 with all the emoji’s, I like 👍 to have a little fun 🤩 with them. Your friend, Jeff.

Sweet

Hell yah man

Cool now I wish I could put air in it

I’m having a hard time breaking the bead you got any tips

Stand the tire up and bounce it around. That will seal it

145/7-60 tires fit on the stock monster Moto rim ?

Nice video. Where did you buy the tiers from? I’m in Canada

What do you do when you dont have an air compressor how do you set the tire so you can pump it up

Do I need sealant around the tired to put the new tires on.?.

Are these tires tubeless I didn't see a tube but there is a valve?

Hey this is Elijah McGaugh i need a 145:70-6

What size tires are those? And what website did you get them off of?

Do you put a inner tube in it ?

How do those sunf tires hold up against goat heads ( sharp spikes thorns)?

Do you prefer tube or tubeless

I feel so bad for those rims...

i broke my finger trying this:(

this is literally impossible

Might want to work on your Mounting technique a lil bit more ,Before you show others....c'mon