Рет қаралды 142,298
I Made a helpful tool, a tapping fixture that helps me tap precisely perpendicular to the workpiece and not mess up the threads. In this tap guide, I can use up to 10mm tap. I have used plywood pieces, 20mm Linear shaft, Linear bearing, 10mm Drill chuck, Bolt 1/2 - 20UNF thread size and 5.5 inches length, 20mm Shaft support, 12mm 2nos. Flange bearings, 20mm 2 nos. Flange linear bearings, Metal parts, Screws, etc.
►Subscribe to my channel and don't forget to click the bell 🔔
/ mistrymaketool
►My Favourite Project Videos:
• How To Make A Spot Wel...
• How To Make A Bench Vi...
• How To Make A Angle Gr...
• How To Make A 9 inch D...
Visit My Official Website:
mistrymaketool...
Social Media:
Facebook Page: / mistrymaketool
Instagram: / mistry_maketool
Pinterest: / _created
Thanks For Watching...
Hit Like & Subscribe Button...
#mistrymaketool #diyproject #tapping