Suppose to fill the filter with oil and rub the top with a lil oil that's all

You did good, Dan!

Man saved himself “my wife is right”!!

Nice job bro.... Love those ramps. Damn I need a set... Anyway bro the lube you spoke of is that you only need to put your finger in some oil & run it around the rubber piece in the filter. I really enjoyed the video ... Glad you & the wife could do it together..

Thanks Dan, I will make sure I have the correct oil filter first. I have a 4 cylinder too. 2.4 liter also.

At least you’re willing to learn and save some money.🇬🇧🇬🇧🇬🇧🇬🇧👍🏻👍🏻👍🏻✌️

Hard to believe this is the 1st time you ever changed your oil. I see all the tips you should know already suggested. Checking the owners manual for capacity. Taking measurement on level ground. Also recheck the level after you run it awhile and let the oil circulate. Wiping some of the used oil on filter gasket before installing. Also all auto supply stores have catalogs or lookup monitors near the oil filters so you can find the correct filter for your vehicle. You did OK for your 1st time.

Next time don't forget to check the bucket for holes 😂😂😂 (thanks 4 the video)

Slob. And very DANGEROUS ramps.

You'd make a good teacher Dan 👍👏

And you just use a lil old oil to lube the filter 👍

Just a heads up since you didn't put any oil on the filter gasket, next time you change it make sure the gasket comes off. If not and you put new filter on, you will have a problem. Also just for your safety chock those back wheels. Overall good job for your first time

Good job but you might want to prime the filter and put some fresh oil around the seal of the filter

Dan you're supposed make sure the oil IS HOT, not let it cool down lol the viscosity of the oil thins out when it's hot allowing allllll the oil to drain properly....and quicker.

I don't know if this was recorded before your neck strain or after but hope that's getting better.. You taught well Dan! Nice to see you Britt💁😘

I think you need to be level when you check the oil. If you look in your owners manual it will tell you exactly how much oil to put in and what type to use. But you did it! You changed your own oil. What a great feeling that must be. I have never done mine, I'm disabled and can't get on the floor. So live and learn, they say.

By the way, I love those ramps, I use 2x4's.

4:00 100% knew this was about to happen.... slippery little devils eh ?

You suppose to put oil on your finger then rub it the oil filter gasket need to check it make sure it's not leaking

Your lubricant is your old oil to just lubricate the new filter lol

Just stick ur finger in new oil and lube the filter👍🏾

You don't fill the oil filter first?

your not supposed 2 check your oil with the car tilted up in the air you need 2 put vechile down and let the oil settle

Did you build those ramps yourself?

Should have filled that filter with oil before you installed it

Help! filter number?

just a tip check your owners manual for amount of oil . car must be level to make accurate oil check not on ramps. oil filter o ring should be wet with new oil before tightening. you will do better next time..

Generic Video😕

Generic Video!