How to drill a small diameter hole in wood evenly and accurately, and avoid sloppy hole edges when the drill exits the material. There are different ways, but each of them is applicable in its specific conditions.
It would seem that it could be simpler ... We clamp a new drill sharpened under a tree into a screwdriver, set up a jig, aim, drill ... and we get this result. Torn out fibers when the drill exits the wood from the back of the hole. This result does not suit me, I need it exactly, evenly, and neatly on both sides, and not just on the front. Well, since I need to do this on a large furniture board, just using a substrate under the part will also not work.
And in this video - the solution found. Fast, accurate, precise.
Video about the conductor:
1) Drill jig | Correct application according to the instructions • Кондуктор для присадки...
2) Furniture jig for drilling holes. You can drill accurately with it! • Мебельный кондуктор дл...
0:00 Intro
0:51 Chips and tears in wood when drilling - causes
1:50 Different ways to drill wood
4:44 Method of drilling holes without chips and tears