Drill Press Setup P2: Arbor & Runout Adjustments

Рет қаралды 39,288

5 жыл бұрын

This video shows the detailed setup & calibration procedure of a drill press, specifically the Porter Cable PCB660DP 15" standing model:
www.portercable.com/products/...
Part 2 items covered:
-Quill motion
-Feed spring tension
-Spindle runout

Пікірлер: 15

@jenalmuttakin1395 4 ай бұрын

Finally found youre video about that problem.. Same problem

@twalsh1490 4 жыл бұрын

Thanks! Just picked up a 20 year old drill press which turns out to have a noticeable runout problem. Looking forward to following your method.

@Gristourdille Жыл бұрын

It's so interesting and useful for me. Thank you!

@jeremykemp3782 2 жыл бұрын

very good video

@markkoons7488 3 жыл бұрын

Bought a 20" Taiwanese drill press third hand. As with other used drill presses, dirt, loose fasteners, and rotted rubber were behind 95% of the problems. It would be nice to know how to clean, lube and adjust chucks, too, wouldn't it?

@altimmons 4 жыл бұрын

I’ve been trying to fix mine for a while. Mine is not new. And it’s second hand. But it’s what I’ve got for now. It used to have a little wobble. Now it has a ton. I cannot figure out where it’s coming from.

@michaell7877 3 жыл бұрын

Where did you get that stand (dial indicator) for the gauge?

@michaelklaman7394 2 жыл бұрын

What is the name of the solvent you used to remove the corrison from the arbor of the drill press?

@jeremykemp3782 2 жыл бұрын

I would have liked to see if there would be any total run-out with the press extended out fully.

@WayneCook306 2 жыл бұрын

That is NOT the correct way to set that adjusting screw, It has a flat spot and you need to remove the quill to adjust it..

@chrisrschroeder Жыл бұрын

Can you describe the correct way to remove the quill and make the adjustment or provide a link?

@deanmiller9039 2 жыл бұрын

Ahhh, am I missing something here? Started out with 9 thou runout, then cleaned it all up and ended up with 9 thou runout which you were happy with. Thus the runout procedure accomplished nothing?

@grooooved 2 жыл бұрын

Yes, you're missing something.

@valuedcustomer9614 2 жыл бұрын

Watch it again. He said run-out improved from 9.0 to 0.5 one-thousandths/inch.

@Hoaxer51 3 ай бұрын

I think what you really want to show is .009, nine thousandths and .005, five thousandths. What you’re showing is 9.0= 9 inches and .5 is a half an inch. Edit: After rewatching the video, he said he had it to one half a thousandths witch is .0005.