I seemed to have sprockets on my mind 🤔… Hope you enjoyed the video! Thanks again for watching the video!
Пікірлер: 8
@Africa10009 ай бұрын
Sound much better now. Thanks!
@lawnmowerjones31609 ай бұрын
Good to here, thanks for letting me know.
@KATHYMEADful9 ай бұрын
The sound on your vid is perfect.
@lawnmowerjones31609 ай бұрын
Hi, Thank you, good to know. Thanks for your comment.
@Herbybandit9 ай бұрын
The mushroom shaped end (non drive side of the cylinder) may be held on with another roll pin , have a good close look also see if you can make out any signs of a thread around the spindle, as it looks like the main shaft withdraws from the drive end, no need to drill a hole to access the recessed pin. If the bottom block rod is siezed then heat and cold cycles help, I spent 3 months trying to get the spindle out of a Marquis 20 inch land roll which was corroded solid! I won in the end😅
@lawnmowerjones31609 ай бұрын
Good evening. Well a Gold star for you. Soon after the Video , i had another go at it. The none drive side with the mushroom shaped holder, did have another small pin to get that off the shaft. And again like the drive gear side another pin going through the cylinder bearing housing stopping the bearing retainer coming out and exposing the bearing that end. If i had drilled a hole in the drive gear side to get the small shaft pin out, it wouldn't have made any difference as there was another pin behind the bearing its self. Dronsfield Bros certainly like there Pins!!! I will do a video next week of it in bits. Thanks for your comment.
@matthewhibbs96029 ай бұрын
you may have to gat a collar machined up for your gear and then weld that onto your gear
@lawnmowerjones31609 ай бұрын
Hi Mathew Yes that is also a good option. After the video I did get the broken part out and is in one piece. Thanks for your comment.