How to install DRP bearing spacers on my 1992 Camaro. Spacer: DRP-007-10521S Seal: DRP-007-10577
Пікірлер: 15
@lostbusproductions84594 ай бұрын
Don't burn yourself out! It would really suck to see you lose your passion. This channel is a treasure trove of information for someone such as myself trying to get an old third gen back in shape. Thanks a bunch for all of it!!
@MrSpartanPaul2 ай бұрын
True true true
@davebarron59392 ай бұрын
This was amazing, I have never heard of, nor seen these, really appreciate all your incites and presentations. Thanks.
@klynsma762 ай бұрын
This is a super cool upgrade.
@jbtOO72 ай бұрын
You're an absolute genius
@replica41323 ай бұрын
Good stuff sir, many thanks for the vids : )
@scottdegeer32024 ай бұрын
Nice job! thanks for the shout out !
@3rdGenGuy14 күн бұрын
Just a FYI: you still need to periodically check the bearing preload. especially if you installed new bearings. as new bearings will wear in a bit and the lash will increase.
@EddyB784 ай бұрын
Thanks 👍 Keep up the good work
@autonomous_collective4 ай бұрын
Nice....Thx
@doolallyproductions72344 ай бұрын
I have the iron hubs and I had to tighten mines all the way down cus it had too much play but they don't spin fast like yours
@3rdGenGuy4 ай бұрын
hubs won't spin free like the start of this video if they are fully greased up.
@Skynyrd-fx2mi3 ай бұрын
Hey I was wondering about my 3rd gen so the hood isn’t aligned properly so the driver side headlight is covered by the hood so it won’t pop up only the passenger side will how do I realigned the hood
@3rdGenGuy3 ай бұрын
you can loosen the hinge bolts and get some wiggle room out of it. hood fitment is an art though. it's a lot of trial and error
@NatbebАй бұрын
I gotta stop watching your videos, you are costing me money 😂😂😂😂