Thank you! Fixed our dryer today. 💁🏻‍♀️ I did need an extra hand taking the belt off and putting it back on though.

Thank you for making the sound first so I could hear if I was having the same issue

That worked well! Even found a service guy around the corner with parts! Took me about two hours and cost $13! Thanks so much. Great video

Thank you..I sprayed a little WD 40 on the the pulley wheel bearings and fixed. I’m sure it’s a temporary remedy but wet laundry is no bueno

this was very helpful. I lubed it once and the squeak came back within a couple months. So, I replaced the wheel. Easy peasy. You don't even have to remove that second silver shield if you are a little dexterous :)

Awesome video. Was not my issue in the end, but the way you took the bottom front panel off and spun the drum allowed me to diagnose mine super easy. The bottom roller is completely shot!!! Good advice to do that to see/hear where the noise is coming from!!

Thanks for video. I sprayed a little lithium grease on the idler pulley and the squeak is gone. Another use for lithium grease. I use it like Frank’s Red Hot!

Thank you! You helped me fix my dryer today. 😀

Great video! Ours was doing the same thing. I just need it to last another another 2 months so I sprayed the wheel with a silicone spray and squeak gone. 👍👍😁 your video pointed me in right direction. Thanks!!

Worked for me! (at least I think so.) The only thing I had to look on another video for was to see pulley path. I didn't need to take lint holder thing off to reach it. But then I took it off anyways to clean it. Thanks for the video.

I would have assumed that awful shrill sound was going to be the belt, but I ordered the part on Amazon, using your link. Hopefully, that is all that it is. Thank you!

Looks real easy boat five minute job

Diving into the unknown always gets my adrenaline pumping. Watching your video helped a lot. I found that all I had to remove was the bottom cover. I could reach in with both hands and comfortably touch the idler pulley. I cut a piece of 1x2 41/4” long and placed it between the vent pipe and the idler bearing shaft/bracket, this removed the pressure on the belt. Then it was easy to remove and replace idle bearing. When I removed the1x2, I made sure the belt was in the right place. Put the cover back on. I was interrupted a couple of times while making my repairs, so I would guess it took less than 10min.

Thanks for the video! I just lubed up the idler and the squeaking went away.

Can you get to everything from the back or only from the front. I hear the noise too so I'm sure it's just the wheel.

Nice

I have a duet dryer suddenly it started making a noise. When we pulled it out from the wall we found the pipe that goes outside was wobbly and that was making the noise. Is there something inside that was holding it still ? If so how do we fix it, for now we have just pushed some foam around the pipe

I have the wgd9150w00 dryer. Ordered a replacement idler pulley from Amazon but it is larger diameter than the original. Also read squealing returned for some after 1 year. Where can I get Original whirlpool quality idler pulley for this model that is an exact match or a better quality one for cheap?

How do I take the whole front panel off?

Mine was making that noise for awhile, then it changed, then it just stopped. Now it won't start. help.