Рет қаралды 9,174
This is the first video of the configuration-series for the E3D Toolchanger. In the initial setup I'll explain how to:
- install the custom E3D RepRap firmware
- setting up WIFI to connect to your printer
- checking the function of all axis and endstops
- verifying the proper execution of tool changes
And perform a test run in the end.
The display in front of the Toolchanger is a 7" PanelDue and is not included in the kit - I will release a video about it shortly.
🤝Please support me:🤝
buy a ToolChanger: geni.us/ToolChanger
Patreon: / renejurack
PayPal: www.paypal.me/renejurack
⚙️🛠Additional parts and tools used (affiliates):
WEIDMÜLLER Stripax: geni.us/stripax
KNIPEX pliers: geni.us/KnipexPliers
WERA L-key color: geni.us/WeraLkeys
WERA micro hex screwdriver set: geni.us/WeraMicro
USB microscope: geni.us/USB_microscope
E3D-Wiki: e3d-online.dozuki.com/c/ToolC...
Facebook-Group about Toolchangers: / 237615240416855
E3D-Discord with TC-Channels: / discord
00:00 - Introduction
00:28 - Intro
00:39 - installing the firmware
02:17 - setting up WIFI
04:42 - checking motion and endstop
07:35 - homing
10:45 - tool change
21:33 - test run
22:40 - outro
Music by Epidemic Sound www.epidemicsound.com/referra...