ES: in this video show how to draw bolt and nut buy use command c, command pol, command ext, command cha, command in, command helix, command su, command ... for more videos please go to my channel thank YOU.
Пікірлер: 18
@pramodmyakal68754 жыл бұрын
please add your voice also somethimes things are not understood
@bpetnoi1472 Жыл бұрын
I believe you did much more work than necessary. I would have made a copy of the bolt and placed it on the nut. I would then use subtract to remove the bolt from the nut leaving threads on the nut. Much easier than making the threads on the nut.
@s.j.graphicsdesignaccounti53403 жыл бұрын
i love it you are the best designer
@douglasvieira18243 жыл бұрын
Thanks. Good job!!👏🏼👏🏼👏🏼👏🏼👏🏼👏🏼
@Eangsopheann3 жыл бұрын
thank you
@zeezoo61745 жыл бұрын
nice viedo :) keep up the good work
@mghvinjilia Жыл бұрын
Sir! Why do you use a triangle two times, one on the bottom and another on the top of the helix to sweep. It would be enough one time?!
@Eangsopheann Жыл бұрын
because of the top one for make thread and buttom to make thread end smooth and look nice.
@umarrider33325 жыл бұрын
If we draw a window in 3d in a specific dimension. But in our project windows dimension not same. Can we insert Windows without making a new window with new dimension.
@halimkhan8789 Жыл бұрын
wonderful
@s.j.graphicsdesignaccounti53403 жыл бұрын
please sir ji make a drone, table fan, celling fan, sofa, table, chair
@IvanJest10 ай бұрын
when using the sweep command, the triangle turned out to be only at the bottom, but not at the top, why?
@Eangsopheann10 ай бұрын
i am not clear about you question please again, Thank you
@weishitang46834 жыл бұрын
对我有启发!好。
@ankitrai22663 жыл бұрын
Add voice bhai sahab
@Lussacregan Жыл бұрын
If you can't say a word, it's not a tutorial, I think you reposted someone's video, editing just clicks 👎