thanks so much for the link and video. I have a bad sender too and just bought the CNC part. Thanks!

Yeah!!! Looking forward to the premere.

Nice job. I added a link card to my video :)

Where do you buy the espeicer for the hold

gah man stuck in traffic again!

the grey panel is not the tank and thier is 2 inches or so from the floor to the top of tank.

thank you for your video i had problem with faul gauge and it as the sender like yours, today came my replacement. The new sender will "lock" in another angle so the metal inside the tank will not be aligned straight angle like before along to the tank, does it makes a difference or a problem? It would be aligned 30º counter clockwise . Old sender was easy to unscrew once i tried turning left just by hand , new sender apart that it locks a little bit more right (30º counter counter clockwise angle as i said) will also lock in position but not feels very tight lock. I cannot turn it more by hand, should i use some tool like long pliers to turn it a little bit more clockwise or once it feels locked by hand then i should not push it more? (i do not want to break anything) If i can turn it a little bit more clockwise then would also be aligned more correctly along with the tank.

Question is "Where did you get the alum. plate?