Yep it is. It’s just like Asda barking except this is a 3rd generation.
@LiftsinEurope3 жыл бұрын
@@LiftEnthusiast2020OFFTOPIC I like Kone Kone Ecodisc Lift
@EverydayEverything3603 жыл бұрын
That's nice to re-visit your childhood lift. My childhood lifts where the ones at the doctors surgery in Waltham Abbey. I swear they were early Gen2s but they could've been late 2000s. Then the what I think was my next lift I went in was the pretty boring Gen2 in Tesco Waltham Abbey which was funnily enough next to the doctors surgery.
@What_The_Fuck_Did_I_Just_Watch3 жыл бұрын
2nd gen EcoDisc fixtures
@EverydayEverything3602 жыл бұрын
If this lift was installed in 2008, you would have been either 5 or 4 years old. You must have been in some lifts before that, like at the hospital when you were born? Same with me, but the lifts at the doctor's surgery were the first ones I remember going in.
@lovemonster40523 жыл бұрын
Nice
@yourlocaltoastcruncher3 жыл бұрын
My first lift I ever ridden was the Pickering lift in morrisons seaford
@misterced46293 жыл бұрын
bro is it okay if i add a GAINT WINDTURBINE because it would look like it is making power with it it will also look very fancy
@laurenceorman52822 жыл бұрын
That was my first lift too
@Ezcah5Channel3 жыл бұрын
I miss filming lifts irl :(
@LiftEnthusiast2020OFFTOPIC3 жыл бұрын
Same
@LiftEnthusiast2020OFFTOPIC3 жыл бұрын
You can still film lifts but with restrictions in place
@rahan5733 жыл бұрын
The motor sounds like a MX06, why do I have a feeling it's a 4:1 MX06 setup.
@LiftEnthusiast2020OFFTOPIC3 жыл бұрын
Probably because it’s a base model of Monogoods
@LiftEnthusiast2020OFFTOPIC3 жыл бұрын
I have every reason to like this lift also.
@rahan5733 жыл бұрын
@@LiftEnthusiast2020OFFTOPIC Yes likely but it's odd to see monogoods use MX06 rather then MX10 but hey it's still probably 4:1 so it's fine. Yes you have every reason to enjoy your childhood lift.