Damn 14 minute tutorial better than some full courses ive enrolled in 😂, straight forward and you never over complicate things 👌🏻👌🏻👌🏻

Gonna attempt to retina my truck next weekend since cali cops pulled me for front tint. Thank you for the tutorial. I need to learn how to do the windshield next

Thanks for the video!

Really good content. Really interesting to watch and really good for learning experience as well would like to see more teaching videos as well

Great video matt

ty for sharing Matt

Just what I needed. Ty ty ty

Love your videos, what apron do you use and recommend

Hey I love the vids but always wondered on cars with tight or even tight ish seals when I fold the film to tuck in the side seals and then roll up the window I notice there's almost like creases you can see in those spots after install. I know not to crease it I'm always careful but sometimes those spots will show or even just tend to be more dry Upton install

what tape do you use on the edges of the window?

Hey! I was wondering what you do if a customers car is dirty. That sounds like a dumb question, but all of the tutorials I see include putting the film on the outside of the car. The obvious remedy is to clear the vehicle... I suppose I'm wondering if customers should be cleaning the thing before getting a tint done. (Specifically asking as I'm hoping to do mobile tints) Amazing video too, by the way. I've subbed! Been looking for something exactly like this.

Legendary content ngl

Is there a video of how to tint with a rain guard?

What kind of tape do you use on the gaskets ?

what are you using for slip these days?

Just have to always check that your bottom edge is equal as the inside edge as not all cars are the same height.If you dont you will have a noticable gap.

Am fixing to order all my tools and some tint 😎

I’m getting fingers on the top of the tint after applying to the inside. What do I do?

what kind of liquid do you use please ? I like it

At 10:00, if you tack it down and its misaligned, can you pull it off and retry?

Question: It seems like a lot of soapy water gets pushed into the door. Why isn’t tint installed from the bottom of the window to the top so that water is pushed out the top instead?

Какой скотч используешь?

So is that like a alternative method of shrinking without having the squeegee down the lines ??

asombroso.

super the only problem i have is i found it impossible to separate the film...

Yup. Haven’t been squeegeeing from the middle out. I’ve noticed many fingers pop out and they’re annoying AF! 😅

What’s the point of heating it on the outside??

How can I order my tinting complete tools to start in Nigerian

Why do I always have trash in my film no matter what or how I install ? I do as best as I can but I always see trash in my work. No creasing just dirt..

how much soap do i have to put in 30 oz of water I’m a beginner

I find bottom loading much easier, less contamination

Anyone please please tell me why he use heat gun at bottom ???

313tint.com

🙏🏻🙏🏻🙏🏻✅

Do you only shrink at the bottom of the window?

Hello, will she be for information every time her makes me little points? You use that she mark film I am in France see if I can find thank you in advance