Рет қаралды 23,614
****Here is the link to the Catia V5 Master Course****
www.udemy.com/...
Huge discount if you use this link to enroll...
------------------------------------------------------------------------------------------------------------------
There are 4 types of Sweeps. Sweep commands are extensively used to create complex surfaces.
1. Explicit
a. With Ref Surface
b. With Two guide curves
c. With Pulling direction
2. Line
a. Two Limits
b. Limit & Middle
c. With Reference Surface
d. With Reference Curve
e. With Tangency Surface
f. With Draft Direction
g. With two Tangency Surfaces
3. Circle
a. Two Guides
b. Two Guides & Radius
c. Center & two Angles
d. Center & radius
e. Two Guides & Tangency Surface
f. One Guide & Tangency Surface
g. Limit Curve & Tangency Surface
4. Conic
a. Two Guide Curves
b. Three Guides Curves
c. Four Guides Curves
d. Five Guide Curves