Hi, @Cgudvangen1. The frequency must be adjusted from your REMOTE device if your "REF" light is "ON." If you wish to adjust the speed from the keypad, B1-01(Frequency Reference Selection) should be set to a zero (Operator) in your programming.

Thank you for your interest in F7, P7, and G7 Troubleshooting for the Machine Operator. The BB is short for Base Block. Here is a link from our Yaskawa Solution Center that covers how to troubleshoot a base block. Link to Yaskawa Solution Center: solutioncenter.yaskawa.com/selfservice/microsites/searchEntry.do Link to the document: bit.ly/3FC7Vyn

Thank you for your interest in "F7, P7, and G7 Troubleshooting for the Machine Operator". Initializing a drive and resetting it to factory default can be done via parameter A1-03. There are two initialization settings, 2-wire or 3-wire. For 2-wire initialization, set parameter A1-03 = 2220. For 3-wire initialization, set parameter A1-03 = 3330. Here is a link to our Yaskawa Solution Center: solutioncenter.yaskawa.com/selfservice/viewdocument.do?noCount=true&externalId=10360&sliceId=1&isLoadPublishedVer=&docType=kc&docTypeID=DT_FREQUENTLYASKEDQUESTIONS_1&stateId=8897&ispopup=true&cmd=displayKCPopup&dialogID=192767&ViewedDocsListHelper=com.kanisa.apps.common.BaseViewedDocsListHelperImpl&openedFromSearchResults=true

Yes, the P7 Series has been discontinued. I recommend reaching out with information about your application to find the best suitable replacement. You can contact our Technical Support Team via the following link: www.yaskawa.com/support-training/support., or select the nearest service provider in your area here: www.yaskawa-global.com/company/profile/global.

@@YaskawaAmerica Can you share with me announcement of discontinuity?

Thank you for interest in F7, P7, and G7 Troubleshooting for the Machine Operator. The B5 group of parameters are for PI control. To better assist you please contact our Technical Support Team at www.yaskawa.com/support-training/support.

Thank you for your interest in the F7, P7, and G7 Troubleshooting for the Machine Operator. Please feel free to contact our Drives Technical Support Group with more details on your application so that we can assist you with selecting the appropriate parameters for your application. Here is the link: www.yaskawa.com/support-training/support. Thank you!

Thank you for the feedback! We will share this with our Technical Training Services team.

Thanks for asking! You can find more information about the CPF00 fault on our Yaskawa Solution Center. Here is a direct link for CPF00: solutioncenter.yaskawa.com/selfservice/viewdocument.do?noCount=true&externalId=10092&sliceId=1&isLoadPublishedVer=&docType=kc&docTypeID=DT_FREQUENTLYASKEDQUESTIONS_1&stateId=98269&cmd=displayKC&dialogID=98268&ViewedDocsListHelper=com.kanisa.apps.common.BaseViewedDocsListHelperImpl&openedFromSearchResults=true