Ditch Witch with tracks has excellent manueverability. Alternate hack for black pipe fittings: use a propane torch to heat/soften the black pipe.

A FAR better hack for installing poly pipe fittings is to use a hand torch on "LOW HEAT" around the poly for 5-10 seconds to make it pliable. Where gloves, heat, slip fitting into pipe and let it cool for a minute. Then use "ALL STAINLESS" clamps. Many stainless clamps are ONLY the band itself and the screw and strap are not as high quality. You may also want to look into something called a (CYCLE STOP VALVE). It can save you a pile of money in the long run as it will help your pump last far longer than it will without due to far less cycles.. Also helps to keep your pressure regulated and can lower the amp draw, further saving the pump and your wallet.

I use 'push to connect' fittings and hose on my cars. They are barbed fittings like those that do not require clamps - that's how tight they go on. You did the hose in a pot of hot water and then jam it on the fitting. I would suggest trying that next time, probably make it a lot easier. No experience with that type of line, just a thought.

You could have made the connection of the poly pipe to any of the pipe connector fittings much easier for yourself, if you had simply dipped end of poly pipe in boiling hot water for 40 seconds each time to make it pliable. Also wondering why you buried the 1/2" shut off valve on the poly pipe just outside the garage? Should that not be left accessible?

Never seen that kind of machinery before, learning something new everyday :) A trencher...

Don't forget to use ss clamps

Excellent work. Love your videos, they're extremely detail oriented, and simply chock full of great information!

Does the pipes freeze in the winter ?