Fault Code P0341: VW Polo 1.2 Timing Chain Failure Nearly Damaged The Valve

No video

Fault Code P0341: VW Polo 1.2 Timing Chain Failure Nearly Damaged The Valve

Рет қаралды 41,135

Enka Motors

Күн бұрын

Пікірлер: 25

@eddkennedy6458 Жыл бұрын

Great explanation on doing this job, thank you.

@lewisjenkins1114 Жыл бұрын

I did this job today on a Seat Ibiza, the right hand chain guide was completely missing, it was in the bottom of the sump and all stuck in the strainer. And those timeing covers are a pain to get back on 😒

@enkamotors7012 Жыл бұрын

Yes I agree!

@lukemeecham1997 4 ай бұрын

When your chain gave up did it smash any valves?

@lewisjenkins1114 4 ай бұрын

@lukemeecham1997 Fortunately the chain hadn't given up, it hs jumped timing slightly on the cams, but no internal engine damage occurred if my memory serves me correct. Most VWAG engines aren't interference engines, meaning it's very unlikely the piston would touch the valves even under complete chain or belt failure 👍🏻

@samwilson7357 7 ай бұрын

Very good thank you for sharing

@TuuSaR-so4ez 3 ай бұрын

It's a design fault, it will eventually hit, regardless how often the oil has been changed.

@charliediver1560 2 жыл бұрын

Great vidio , thanks for posting .

@varunesh123 2 жыл бұрын

How much miles did the vehicle run before chain replacement?

@jeffreyrichards6119 6 ай бұрын

Great video thanks but where is the crankshaft senor to ??? Is only thing missing

@enkamotors7012 6 ай бұрын

The crankshaft sensor is located at the back of the engine, under the intake manifold on the engine block

@thezerocool22 Жыл бұрын

brilliant vid, keep it up! Out of interest, can you inspect the chain without removing the cover, for example the plastic cover just above the oil filter housing?

@everybodyneedsadave 11 ай бұрын

No you can't

@lukemeecham1997 4 ай бұрын

If your chain snaps will I need to replace valves or is this a non interference head?

@enkamotors7012 4 ай бұрын

Yes, if the chain snaps the valves will need to be replaced.

@colinbryant5531 2 ай бұрын

Does the tensioner need a gasket?

@enkamotors7012 2 ай бұрын

No you don’t need a gasket

@jcgenuino9272 6 ай бұрын

Hi how about bent valves, were u able to check them??

@enkamotors7012 6 ай бұрын

There was no problem with bent valves as there was no snap or jump. I hope it helps.

@Ozkan2106 11 ай бұрын

is it possible to chance just the tensioner alone? just screwing the tensioner from outside , without to disasembly the hole thing?

@enkamotors7012 11 ай бұрын

No, you cannot reach the tensioner without removing the lid but the problem is usually due to the chain stretching so the everything inside must be changed. Hope this helps

@Ozkan2106 11 ай бұрын

@@enkamotors7012 Thanx for the repley!

@everybodyneedsadave 4 ай бұрын