FEM Case study 1: Investigating how a gear will fail under high forces with SolidWorks Simulation
Рет қаралды 26,164
Күн бұрынFinite Element Method - case study. Using SolidWorks Simulation (FEM-software) to analyse how a gear will fail when transferring large forces. A solidworks vectorplot is created to show the way the gear will fail.
Summary: The moment on a gear-tooth leads to high tensile stress at the base of the tooth which will lead to high shear-stress, which will shear the tooth right at the base.
@emmamupemba2200 Жыл бұрын
Can I do this to analyse how a gear tooth will deflect ?
@marcinchilik9671 5 жыл бұрын
If you want to know when something breaks you compare stress with ultimate stress (Ftu) not yield stress (Fty).
@littlerp2 5 жыл бұрын
Right, but if you want to design something properly you should keep it operationally within yield range so that it doesn't experience permanent deformation and possible loss of function.
@thepartsrunner5758 4 жыл бұрын
In the real world, another gear is making contact in at least a couple areas.
@Tkrv77 6 жыл бұрын
You sounda bit carrabean maaan. but thanks
ABAQUS SIMULATION
Рет қаралды 1,2 М.
Fabiosa Best Lifehacks
Рет қаралды 28 МЛН
Jos van Kreij
Рет қаралды 31 М.
Jos van Kreij
Рет қаралды 121 М.
SOLIDWORKS AND ANSYS TUTOR
Рет қаралды 10 М.