instagram → instagram.com/hokutosekine/?hl=ja

OMG, you killed me when you pulled out the oscillator 😳

Exact same thing happened to my TS 75. I’m ordering a new armature. hope thats my issue. My housing wasn’t fried like yours though.

This happened to my saw as well, but when I put it together again with a brand new motor housing it was just making weird noises and turned slowly. Any suggestions on what I may have done wrong?

Awesome video! Would you mind sharing how you connected the other cables to the engine?

Awesome job!!!! 👌🏻

OMG This is Festool destruction not repair !!!! are you kidding me. The rotor and stator are going off from the other side. You cant just cut the plastik.

Das schwarze Kunststoffteil zwischen Kommutator und hinterem Lager, sollte sich nicht frei drehen. Es dient als Rückmeldung an die Elektronik zur Drehzahlerkennung.

ok dude, your woodwork projects are astonishing! BUT concerning how you treat your TS55: If you like to resaw !_50mm_! hardwood (probably oak) with "ts55 + fine tooth saw blade HW W48" on 1st and 2nd speed?!!! I have bad news for Г p.s. have you tried connecting this saw with some "flimsy 50 meter power cord extender" and sawing concrete? (probably this type of saw will melt into a puddle) p.p.s translated with google translate

He sure don't like any grease on he's hands.🤣🤣🤣🤣

Esta bien wey desde el pincipio eran los carbones, la rompio a lo menso, todavia aguanta el colector.

is ther not another way to decuntruct than cutting the part? ... i just neet to change a broken part ...

Надо ротор менять. Сам не перепаяешь.

Did you find the Problem. I have the same problem on my saw. Maybe we can help each other.

I think you will need a new one 😂😂😂

🤔👍✋

😆

Da zahlt man 600 euro , und dann so was.