I'll tell you what, if you ever fail it won't be from lack of trying. You're a hard-working son of a gun, very efficient. Great truck by the way.

"Good times?" Any time with Dad is a good time for Yenko! You really push the limits on challenges, great job and no major catastrophes.

114 Dairy Farms left in the State of New Jersey. We stopped farming in 67, miss it all the time.

Heck yeah man...PA is Mack Country. You're channel just popped into my recommended because of that Mack. Can't wait to see your journeys with that beautiful truck.

Looking at that dash brings back memories! You can't beat a Mack, they will beat you back! Concrete roads in cold climates are beyond ignorant !

That's turkey barns there along the northeast extention of the turnpike. All them pots are heading in and out of JBS Souderton. Wouldn't be surprised if the cull cows from your area don't end up down here too.

Duffy, half the wiring on the trailer is for the blackout driving lights. The other half is for standard trailer lights.

First tractor I drove was a 74 R600 237 6spd. Pulling tri axel flats hauling scrap steel. 50,ooo kg gross(110k lbs) that had a 6" strait pipe on it and she sure would talk n send sparks in the dark pulling the mountains. Thing I did most in that truck was shift...constantly shifting. But was 19years old n Trucking. Good times.

Before you replace the rear brake chambers , check the brake adjustment and grease the slacks and S cams

At Quakertown you were about 1 or 2 miles from my uncle and cousins dairy farm. I knew where you were at that point. Keep up the good videos. Thanks.

The wheels on the trailer are called bud wheels.... The nut lets you take the outter off, the sleeve lets you take the inner off, then your stud holds both. Theres a socket for those that'll fit both, one side will have the hex to fit the nut, and a square to fit the sleeve. Each needs to be torqued individually too

You are, without a doubt, a MOVER & SHAKER !!!!! Well done.

Over the past decade, New Jersey witnessed the closure of more than half its dairy farms. Today, the number of commercial dairy farms statewide totals approximately 114.

When you bobtail an R model Mack, all roads are rough. I have put a lot of miles in a R model. Mostly running flatbed hauling construction materials.

114 Dairy farms with 26,000 cows and replacement heifers. According to New Jersey Department of Agriculture

Going for the tanker in the Mack with the dog reminds me of Mad Max 2: The Road Warrior LOL

Looking forward to seeing you turn the fuel tanker into a manure wagon. I think it's a pretty good idea. Safe travels home bud

A single stack Mack with a can on the back!! 💨💨👌👌

The trailer wheels are called Stud Piloted.. Right and left hand thread

Great job on the video Chris and Yenko Great trip so far hope the rest of the trip is good. Hope you have a great safe trip home. Take Care

Nice old truck. We need Kate in more videos.

The big green tractor was a HET. It was used to to transport parks.

You’re going to love the truck.. I have had one for years and haul antique tractors with it..

dammm with that army truck and tank had visions of mad max on the way home nice rig though

Man what an adventure. Yenko is like man what in the heck have you gotten me into this time...

Love the OBS Ford following you when you showed the sod farms..

Yenko rocking 2 the music. 🎾

That’s a SWEET looking Super liner your friends have and the ole bull dog should be a good asset to the farm

Haha finally a video of you in Jersey! I’m from Sussex county

The hood issue ,take old leather glove grease booth sides, lay on hood support n close hood, will "shim" hood up slightly, grease help keep quiet.

See, I said they are geared a little slower, but at the end of the day, they're right up there with the rest! you're the coolest trucker out there! you're a sod buster, are you not!! Don't forget your dog!

Maybe a moving blanket for Yenko, so he can get his proper rest.

Couldn’t be a trip without Yanko. Great buy for both. Your vision of what things can be is inspiring

That is one sweet set up. Man that’s a nice rig

Great tanker. That will haul.

You were in my old stomping grounds, Quakertown and south to West Chester, over to South Jersey and surrounding areas. I don’t really miss it up there lol. Too cold and too many people 😆 Those Onan pumps are very sought after for water haulers. My friends have a swimming pool water hauling business, he has about a dozen trailers with those engines.

Hello Chris nice run

Yeah all the grass for Fenway is grown in southern RI.

You could use that fuel pump motor for the manure tank. To replace the tractor.🤩👍

I just crossed that same bridge into jersey to the first Walmart to pick up a box truck and tow it back last week

Gotta say this is one of your most interesting videos.

Glad you had minimal problems getting there and back for the tanker. $25 bridge toll sucks, but if that is your worst problem--hurrah! "Helluva deal!" Good thing you had Yenko with you to keep things rolling! (18:52) Now homebound! Good Luck!

Love superliners and don't worry that's just spine exercise

If your brakes don’t set fast it may be a quick release valve hanging up

Alderfers poultry farm on the left and Jaindl Turkey farm on the right on the Pa turnpike. You drive through my neck of the woods

Yenko says , " I 'm going to need a beer after this dad !!!!!

Good Content Chris.

I could be wrong but I'm pretty sure being a military trailer it's 24 V but you said you're going to rewire it anyway so that solves that problem. As for the wheels: you takeoff the nuts the outside wheel comes off, and then you takeoff the square headed stud which is usually the opposite thread direction and the inside wheel comes off. They sell a socket that's multi use it has the hex for the nut and the square inside for the stud. For the brakes on the road tractor you can actually hear when you pull the button out and the brakes come on it sounds like it takes quite a while for the air to dump out of the brake chambers. Probably one of those aluminum brake valves is releasing slowly. Especially if the trucks been sitting. What I do is take off the line where it comes out of the compressor or air dryer if it has one right before it goes to the air tank. And spray some WD-40 in there and then air the truck up and pump the brakes and cycle everything a bunch of times and things start working a lot better. I give you credit lol if I tried pulling that trailer with no lights no registration I'd be typing this comment from DOT jail haha

I always liked the good old R model Mack’s

Great job Duffy loved it was really great love driving no elec on trailer good wrenching as always thank you for sharing and your time and Happy Holidays was great.

I love seeing these old trucks still working this new junk on the roads with the pollution garbage on them spend more time in the shop.

With this camouflage the deere will only see a red Mack appear on the field😜

You need to Cary a pillow for yanko to lay his head on !!❤

First time I've seen you drive the slow lane 😅

Great video Duffy! I’m enjoying your adventure.

Great video !

Might as well run those trailer tires till they are shot. Start looking for different wheels 11-20 are hard to find and spendy. Nothing wrong with stud pilot aka buds wheels. Anti seize when mounting and you’re good

All the stock lightbulbs on that trailer are 24 volt. Standard military. Also, those tires are pretty sketchy on wet roads, or ice. Tube type.

Chris there is nothing wrong with the brake can's the brakes need to be adjusted on the tractor they look NOS I'm pretty sure the government use's 24 volt all the lights on trailer will have to be replaced with 12 volt there are 3 of them tankers in my neck of the woods they put all led's brake lights on there tankers

Probably not far from the Mack factory in Allentown PA. I got a tour of there when I was going to SUNY Morrisville. I was never a Mack guy but I sure can appreciate a sharp r model or superliner

Oshkosh are the shit with the 6x6 wheel drive

after riding in the Mack on cement roads Yenko is going to need to see a chiropractor ! LOL

Now only Pigpen and Spidermike missing for a new episode of "Convoy"

Tractor from Mad Max (with dog), trailer from Convoy. Nice

One of my best friends family farms 500 acres and 200 beef cows in Jersey and I always joke with them that they’re just hobby farmers

You gotta keep those fenders. They are sweet.

Should've brought the bean bag for yenco

The woman was running a vacuum trailer picking up leaves and grass clippings

Loving it!

That Mack where the combined was almost looked like one lonely farmers stuff.

Make a extra box next to the toolbox

That motor is good for manure pump

You can't make money or friend paying that kind of shipping costs ! Nice tanker .

I think there is 46 dairy farms left in New Jersey . My family owns 2 feed stores close to ware you were driving in Burlington county NJ

That motor and pump is a Onan diesel they are good keep it around for something I took one off a trailer just like that and made a portable pump for around around the strip mines

These old mack with canrel back ride rough

It should have two baffles in that trailer. Trailer is 24volt

That trailer will be 24 vdc, the original trailer plug is 24 volt. You'll have to change trailer to 12 vdc.

The only thing missing is Dirty Lyle

Take a look at that pump motor. Might be a Cummins 4bt. If that the case, you could swap it into a jeep.

there is dairy near me in southern Ohio that is going to put robots in I hope I can get the chance to see how they work

You should cut those fenders in half right at the mark where the front of the tanker is, just so it wont kick a bunch of crap on the back of the truck and window when driving.

Nice buy, looks like a hell of a tanker

Gillar gmc tack för filmen hade en german shepherdog he loved all caind of vehhicals he lov to ride on pick up bed

Your pump looks like a Gorman Rupp T4 pump. Good piece of hardware. Don’t junk it. You can still get parts for them. I work for a Gorman rupp dealer.

Can you leave the pump on and use as a nurse trailer when fields are too wet for semi trucks 🚛

Onan the best little motors got one in my John Deere 4100 !

The ginat monster truck iirc was used to move tanks as the tracks on them would tear roads up like no tommorow. So it will atleast pull 70+ tonnes (tanks are heavy boys)

They r bud wheel the big hug nut come off then the smaller ones come off to remove inner tire

I think those m970 trailers ran cummins 4bt motors for the pump. Lot of uses for those people swap them into jeeps ,Ford rangers etc. I think they also do swaps on Old whites and olivers and I think some of the older case ih had those in them. Any idea on how your going to mount the fan and pump on that yet? That under carriage for the power plant looks heavy duty could probably rig up something on that to be a center mount kinda like fff new trailer.

It's a tank retriever thay are wicked Detroit power 8 wheel drive

last time i checked there was less then 35 Dairy's left in NJ

Are you gonna use the tank on the other mack?? If not is it a option to take the nursing boom and such from it to put on the armytank

cattle/livestock hauling looks glamorous, but in reality, it's tough...you're hauling live animals, have to keep them up, so you stop so often to do that, and if animals die...you pay for them...

You can make a great lil generator with that engine I've seen people hook them up direct to a pto generator for a tractor they worked great

Military vehicles don't have Vin Numbers. Tough to register.

i like the dog, the truck is crap,the tanker is good

Leave the truck normal and rewire the trailer to the standard plug. That way your truck can pull ant trailer and and truck can pull the trailer. GROTE lights have a color code standard plug diagram.

Did you say 1,150 bucks for 28 pound package? Next time call me I'll deliver it for ya for 1,125. lol Take care Duff.

Look like Duell movie