Thanks! this is a handy one, fresh or salt water.

I did this knot while fishing in the morning on my kayak, by the time i finished i had unknowingly floated 900 miles out to sea

Tied the Alberto backwards, ALMOST always your mono/flouro is thicker than your braid. Wrap braid around mono!!!! IMPORTANT that the wrapping line exits the "loop" to the same side it entered. For offshore we tie a lot of 40 or 50lb flouro to 30lb braid. Could you imagine trying to wrap 40 lb flouro around braid?? Good luck with that!

I have used this Carrot knot in conjunction with the Bimini Twist for over 50 years, and never had a fail !.

I do this one immediately... In my life I always do the double albright knot with satisfaction and a minimal mistakes on a spinning fishing session... but this one appear more accurated and even with a small diameters such as in an eging braid and mono is easy to see every turn of the lines. Thanks a lot 👍🏻

Good knot. Not sure but I believe it's called the Alberto knot.

This is the Albright knot in reverse. Instead of wrapping the braid around the mono, you wrap the mono around the braid. Brilliant!

Looks like a great knot but the albright seems a lot quicker and easier. I also feel wrapping the braid around the mono makes the knot stronger and gives it a lower profile.

This knot looks easier for my old arthritis fingers 😊

Thanks!

I like the double uni knot.

Perfeição !!!!!! Top !!!!

Smaller the knot the better! May be fine with bigger pole eyelets but for me FG is the bomb and double uni are my go tools but I like to learn new things...nice video

Awesome now I am done with fg knot thank God 💚💚💚💚💚

Braid should wrap around the leader as it will go through the rings better and the reel

Awesome and super easy to tie !!! I'll be trying it next trip out, next week! TYVM!!!

Without even talking, dude is able to teach us how to tie these knots. Thank you so much for your content.

Carrot = Alberto….Great knot! When casting jigs for walleye my trilene knot at the jig will fail on snags and the Alberto never lets go.

All backwards. Braid around mono or floro. And top of carrot goes towards reel. So you can cast without getting hung up.

You need to do it in reverse like the Alberto Knot. The tag end doesn’t catch on the eyes when casting. Wrap the braid around the fluorocarbon.

thank you, the fishing knot is very good and easy to apply

Great knot but would never put a flame near my line. If you look closely You can see the melting of the mono/ flouro at the knot. It’s unnecessary and can only weaken the line. Especially if you are bouncing on the waves. Your method looks simple and quick other than the fire. Thank you I’m going to try it

Я пользовался узлом Олбрайт до того, как узнал про узел Морковка. Морковка получатся тоньше и надежнее, узел Олбрайт у меня нередко распускался.

Wow, that is quick knot to tie. I will remember this when I need to rigged up quick.

Terima kasih perkongsiannya bang...Salam satu hobby🤝🏽

Ahh you gotta Hawk Tuah and spit on that thang. Nice knot.

Sama kuatnya FG knot, tp ini lebih mudah

I wonder what breaking strain versus the uni knot ?

I like the knot for sure looks simple enough to tile. I will play with it but the FG knot is still my go to.

Wonderful! I think it is strong like the F.G knot

This is a great knot I have used for 10 years. You need to tie the braid in a loop with a knot and do a half granny knot on the leader. If these steps aren’t done your knot won’t be as strong. I’ve spent many hours testing knots to prove it.

I needed to learn how to tie a leader to braid and just started trying things and this is what i eventually came up with except i double up both lines. Glad i know what its called now

I usually wrap the braid around the mono,don’t know which is stronger but works well.

It’s just like the Alberto knot. Way easier wrapping braid over Flouro just FYI for guys trying this knot.

Thank s for show another ways of method to tide the knot 2 different kinds of lines👍👍up.

Thank you for sharing my friend new friend watching

Thanks for the video. I learned that as being the worm knot.

Thankyou I was always breaking off now that I know the correct way I will be ok thanks man I'm going to use that connection of lines when needed appreciate you thanks

Always use Berkley because it is always a good line. Never has failed me. Also, made in the USA which is important to me.

This is the best lead feeds smooth casting barely can tell switch I'm just beginning but as all beginners learning a whole lot about knots looking forward to much more tips and ??? WWay CCool thanks

great sir, greetings from indonesian fishing

The proper Alberto is knot is my favorite knot. I use it every time I fish. If I free line it’s the Alberto knot 100% of the time. Super strong and easy on the guides.

Yeah Ill stick with the Alberto. Been using it for over a decade with out a problem. Its simple, fast, and hard to get wrong. It may not be the strongest knot but Im fishing for bass, not Atlantic blue marlin. Try tying this knot or knots like the FG on a windy day on a pitching bass boat in foot rollers. Good luck!

looks like a reverse albright knot, would be interesting to see which is strongest of the two

Improved Albright been tying it for years. And no way it's 1000 x stronger that the line

So many knot vids.....many are similar in nature & look effective. My only problem with braided(20lb) main to fluorocarbon(~8lb) leader....these smaller diameter lines are IMO more difficult to tie with some of these videos....if not the double uni...it's a swivel which also prevents line twist for the win.

Seems like a modified becket bend or sheet bend knot. The only difference is instead of wrapping the smaller diameter line around the bite of bigger diameter once, you did it many times and then retraced it and THEN put it back through the loop. Very interesting I'll definitely be using this from now on

Gostei desse nó, vou treinar pra fazer ele😊

Mate, Brilliant! .. Thank you.

Nice. Thanks for sharing your knot tying abilities. I will definitely use this knot. Thanks

Improved albright knot.

Muy bueno 👍 Pero el nudo siempre deforma la linea adelgazándola en alguna parte, se ve claro al final del video. ✅

it is an albright knot made in reverse by spinning the nylon instead of the braided thread

Yeah I’m gonna pack gloves and put them on every time I want to tie on a leader. I use Albright knot, no gloves, 60 seconds and I’m fishing and haven’t had a failure in 20 plus years.

Oh again. Loon UV Knot Sense is the shit for finishing knots. No melting, no super glue, no BS. You all have a lot to learn.

A nice-looking knot, but, in my opinion, a hybridisation of the Yucatan and Carrot Knot. The true Carrot Knot goes by several different names - Carrot Knot, Bullet Knot, Mahin Leader Knot, and always starts with an Overhead Knot (Granny Knot) usually on the leader line. Once completed, you have a knot with all the tag ends at the back of the knot and all the wraps at the front of the knot forming a close approximation to a 'carrot' or 'bullet' from which it derives its name. Normally, the main line, like braid, will be thinner than the leader line material, so it makes sense to make the overhead knot on the thicker material. But should your main line be thicker than your leader line - say 20 lbs main line to 12 lbs fluoro, you are better off making the overhead knot on the main line and using the thinner leader line to make the wraps. It will be just as strong, but not as stream-lines since your wraps will now be facing inwards towards the reel rather than outwards in the direction of cast.

Ikatan nya Sangat bagus kuat dan rapih Mr🤔👍🎣🔔💪

knots such as this are not so easy to do on the bank or in the boat with the wind howling into your face, for this reason I find that a simple 6 wrap surgeons knot is much easier to do when I am attaching my fluorocarbon leader to my braid

The braid should be wrap around and biting to flouri leader, not the other way around

Mantep sekali cari ngiteket nya 👍👍👍

In some places this knot is called the Alberto Knot.

The fluorocarbon looked very stressed at the end of the knot

Great video thanks .😊

Strong knot but despite wetting the knot you can see the friction on the leader between the knot and the leader which makes it vulnerable

Excellent knot

Great demo except it would be better if you lubed up the line before you start pulling on the lines! Will help prevent burning the mono from the friction.

This is the alberto knot I think? Seems the same. Great knot!

thanks best knot ever and esay thanks a lot

Did you know that instead of using that highly functional $1 USD nailclipper (which you don't care if you drop in the water because you have three more in your bag) that you could spend $80 USD on a clipper from Simms that doesn't work as well and is just as easy to lose? You're welcome.

Gostei vou começar a usar esse nó

Ikatan knot yang cukup kemas dan padu 👍🏻👍🏻👍🏻

Thanks for sharing

I have had 400 pound + fish on an FG knot, 80lb braid to 80lb floro/wire rigs. Rod will break before the knot would give. Yes, use gloves to fully tighten knot. Melt floro end with lighter so you have a small nub. Finish with half hitches. super glue the knot where it does not overlap the floro...if you have time. This works for all sizes of braid to floro, I use it with 10lb braid to 20lb floro inshore. Will not fail if tied correctly.

Albright special is my go to knot for braid to mono

I only use this knot on light tackle for bait fishing or small fish or in some cases where my gear is very heavy and overkill for the drag requirements it’s impact strength is not that great and it can slip if too few turns are used! I use my own modified fg or Bimini then to this knot or another similar that was taught to me by Phil Atkinson and he called it the tony Jones leader knot

Seeing him wear gloves to tighten that is no joke. Tried it without and the braid went right into my skin

Simple knots work fine for inshore fishing. Its about teeth and abrasion. Surgeons knot works fine tied in 10 seconds. Then I use FC with a renzetti finish for light freshwater.

I tied this knot the other night with the line still on spools. I wet it, cinched it down, and proceeded to pull. It only took about 10# of force for the knot to slip and come untied.

Нет слов,как хорошо!

this is easy to tie and very narrow for connecting lines /leaders to run smooth through fishing rod guides .. but what about overall knot strength in comparison and which material line first? the fluro or the braid for step one?.. like this knot!

Hey Fishing knots, love your content! I subscribed to your channel

매듭법에 강도는 역시 침이였군요 ^^

Well done, you just created a bigger version of the Alberto. LOL

Decent knot but definitely tapered the wrong direction for casting. Like others have said wrapping the braid round the mono is better for sure

Knots master !!

We call it the Crazy Alberto knot

Looks like a modafied Albright or Crazy Alberto. But it will be smaller if you wrap the braid around the mono.

This channel is maximum dope 👍🏼

That’s a backwards RP or Alberto knot. Been used in Southern California for years.

That’s the easiest way I’ve ever seen it done 🤓👍

A allegory for “there’s a right way to do things and a wrong way to do things”. -reverse Alberto Knot, you can see the damage line on the left.

Congratulation on lessen ur leader strenght

Bagus,cuma leader spertinya rusak

I know the FG is the strongest know but this knot is so fast and easy. Sometime good enough is all you need.

This is a Crazy Alberto Knot

I guess if your pass time is tying knots,..... I like to fish.

You got soft hands brother 👨🏿‍🦳

similar to alberto or the same?

Хорошо показывать на толстой леске ,а если #0,3😊

I would be concerned with the damage on the leader immediately adjacent to the knot where it has burnt/stressed the leader